USER MANUAL PRO USB PRO SERIES AUDIO INTERFACE USB AUDIO DIRECT BOX DESIGN & MADE IN TAIWAN Index GENERAL PRECAUTION BEFORE USE PRODUCT OVERVIEW CAUTION PARAMETER TEST CONDITIONS FEATURES CONNECT TO COMPUTER CONNECT TO MOBILE PHONE APPEARANCE PARTS & FUNCTIONS CT7601SR USB/DSD AUDIO BRIDGE CS43131 DIGITAL AUDIO CONVERTER & HA ISO TRANSFORMER SCHEMATIC TYPE-C PLAYBACK MONITOR TYPE-C SIGNAL SOURCE ACTIVE INDICATOR ELIMINATING GROUND LOOP NOISE SYSTEM CONNECTION GUIDE SPECIFICATIONS UNiKA Electronic Co.
UNiKA PRO USB User Manual GENERAL PRECAUTION BEFORE USE Thank you for purchasing the UNiKA PRO SERIES AUDIO INTERFACE. Before using, please read this manual carefully and pay attention to every detail that you must pay attention to. If you use a mixer to connect to this interface, please turn off the mixer power and +48V phantom power before connecting, and then turn on the power and phantom power after inserting the signal cables.
UNiKA PRO USB User Manual CAUTION This product has undergone rigorous inspection before leaving the factory. If customers encounter failures during use, please contact your local dealer or distributor for replacement or repairing, do not disassemble the case or replace parts by yourself, which will invalidate the warranty. For details, please refer to the warranty regulations in the enclosed warranty card, and fill in the details, and get a valid stamp or signature of the dealer or distributor.
UNiKA PRO USB User Manual CONNECT TO COMPUTER If you need to use the ASIO driver to play DSD stream files in WINDOWS 10, or connect PRO USB it the WINDOWS 7 system, please download the driver from the official website: https://www.unikapro.com/support/download/ File name: UNiKA ASIO_DSD_driver_ENG_20201208 MacOSX no need to install ASIO driver either play normal music format or DSD.
UNiKA PRO USB User Manual APPEARANCE PARTS & FUNCTIONS ① Left channel signal output: XLR terminal, isolated transformer's balanced output, no need to use +48V phantom power. ① ② ③ ④ ② Output grounding/floating switch: when the switch is not pressed,the first pin (PIN-1) of XLR is grounded. PIN-1 will be disconnected from ground after pressing. This button should depend on the system. Used in the situation, in order to isolate the ground loop noise or leakage.
UNiKA PRO USB User Manual CT7601SR USB/DSD AUDIO BRIDGE OVERVIEW CT-7601SR is a single chip audio USB 2.0/1.1 playback and record bridge. It compatible with Windows, Mac OS, iOS and Android and plug and play no need extra driver. AUDIO DECODING CAPACITY • PCM (Stereo) support up to 192KHz/32bit through USB port. • DSD (Native) support 2x bandwidth through USB port.
UNiKA PRO USB User Manual FEATURES • Enhanced ΔΣ oversampling DAC architecture - 32-bit resolution - Up to 384-kHz sampling rate - Low clock jitter sensitivity - Auto mute detection • Integrated high performance, ground-centered stereo headphone outputs • 130dB dynamic range (A-weighted) • -115dB total harmonic distortion + noise (THD+N) • 110dB inter-channel isolation • Up to 2-Vrms stereo output • Headphone power output, 30mW per channel into 32Ω/ 5mW per channel into 600Ω • Headphone detection, Headpho
UNiKA PRO USB User Manual TYPE-C PLAYBACK PRO USB is equipped with the most mainstream TYPE-C USB (2.0) terminal to connect to variety mobile devices and computers, and is accompanied by a music beat indicator on the lest side of TYPE-C socket. There are many TYPE-C conversion terminals on the market, and it is recommended to use qualified the products avoid transmission failures.
UNiKA PRO USB User Manual SYSTEM CONNECTION GUIDE Tablet TYPE-C USB iOS Android Mac OSX Connected by ISO OUT balanced wire to the mixer. No need to provide phantom power.
UNiKA PRO USB User Manual SPECIFICATIONS (Specifications are subject to change without notice.) PRO USB Circuit principle Passive/Transformer balance output USB Version & connector Ver 2.
EU DECLARATION OF CONFORMITY 1. Equipment Product name USB Audio direct box Model PRO-USB EAN Code 4711064410259 2. Manufacturer Manufacturer UNiKA Electronic Co.,Ltd. Address 6F, No.168, Xinhu 2nd Roadn, Nei-Hu, Taipei, Taiwan 3. This declaration of conformity is issued under the sole responsibility of the manufacturer. 4. Object of the declaration, Product: Direct box for musical instrument and A/V device. 5.
