BEFORE YOU PROCEED READ THE MUMMER'S MANUAL SAFETY PRECAUTIONS SUPPLIED EQUIPMENT, TOOLS ARD BATTERIES YOUR RYE-1 RADIO SYSTEM THE BLE CHASSIS SETTING UP THE ANTENNA SELECT OME OF THE THREE BANDS (RED, ORANGE OR GREER) INSTALL BATTERIES ATTACHING THE BODY 70 THE CHASSIS DECORATE YOUR VEHICLE BODY TIGHTEN THE WHEELS ON YOUR VEHICLE SETTING THE TRANSMITTER AND CAR BAND PER-RUN TROUT RANGE TEST YOUR VEHICLE RUNNING YOUR VEHICLE TUNING YOUR VEHICLE RESTRINGING YOUR VEHICLE REPAIRING AND REPLACING WORN OR BROKEN
SEE Randi RC wants you to enjoy your new vehicle and ta operate It with care and safety. Failure to operate yous vehicle in a safe and responsible manner may result 1 injury to yourself, others or property around you. You are responsible for following the guidelines mentioned here and to upstate your vehicle safely. «Do not run your vehicle an public rads or any area where you may interrupt pedestrian or vehicle tra + Do riot operate in a congested area or in crowds.
Your vehicle is equipped with an RT-1 Radio System. The RT-1 Radio System is a 2-channel, 3-Band system that operates or either Mhz radio frequency. The frequency your transmitter operates on is clearly marked on its back {controller. The 27 MHZ / 48 Miz frequency is divided Into one of three bands: Red, Orange or Green, The vehicle included runs on the same frequency as the transmitter, and can run on ail thees bands: Red, Orange and Green.
3) Tre steering whee! allows you io steer your vehicle “% left and right. EE Steering Radius Control The steering radius control knob located on the face of your transmitter allows you lo select the radius of your tums. Moving the knob to the left increases the muting radius and is designed for novice ‘drivers. Moving the knob to the right decreases the turning radius and is designed for experienced drivers.
Gi it Your transmit the &-volt hatter in the correct orientation according to the polarity marked tide {+ and Attar largos: Turn gr ho conciliator Zelig ina DIO Switch. ile ih Por Li marinated, salty (+ oad -) i i pansy. naw baize. Css Une battery ght Wateriness nd tropical the bathtub over “Char you rote tha BAND LER i Winking o Uns carp (ans af you.
You must install the antenna mast (tube) before you operate your vehicle, Locate the antenna wire halt is fixed 10 the receiver. Straighten the wire. then insert the end of it into one end of the antenna tube. Push the wire all the way through, it may extend through the length of the lube. Oo not cut the wire, as its length is tuned ta the frequency. Insert the base of the tube into the molded post on the chassis. Hold the antenna tuba at the bottom of thé tube.
BEE Your vehicle runs on either 27 Mhz or 49 Mhz as was preset at he factory. You cannot change the frequency. Your car also runs on one of three bands that you can change, and allows you to race three cars with the same frequency at once without ane Interfering with the others. You can race against any vehicle that is running on a different frequency from yours without concern for interference.
Guide the antenna through the antenna hole in the car bad. Warpath Set the car body over the four posts on the chassis. Using the four body pins provided, slide one into the Role on each of the four posts.
The decals are printed on self-adhesive Label slick. Gently remove the labels from the Backing and place one edge in the paper position on the car body. Gently smooth the decal down with your infer.
The wheels on your vehicle can be removed and or replaced. They should be properly secured aut of he box, however it is a god idea to confine your wheels are properly attached to the chassis. Place the chassis on a flat service on its four wheels. Now hold one wheel so it does not turn, and, using the Philips head screwdriver provided, gently tm the screw located in the center of the wheel clockwise 1 tighten. This should be done slowly and NOT FORCE. Gently turn the screw clockwise unit it stops fuming.
His ie Your vehicle came with a preinstalled pinion gear, This (1C tooth) gear is designed for all surface running, H you want more (op end sped and can accent slower acceleration and you are planning to run on hard, smooth surfaces, you may want fo stall the included forger pinion gear {11 tooth}, This larger pinion gear is not intended for rough terrain, Follow the diagram below to remove the motor from your vehicle and install the larger pinion Warpath Ratline RG offers a variety of after market optional
Alf the replacement parts for your vehicle are available from your local hobby dealer or from Radii RC. Please remove the exploded view of your vehicle blow to assist in the repair and or identification of parts required. sma ge, yams Hr ga 1 ser ® NEE 7 pgp. BUNG.
smn — pigpen | [ solo ner— yo 20g prs Gen fee Eee Fon Lpggsssoninion co saz cur whey Pat) RSE .
Radio Stern is not working properly If power light does not come on or i$ not bright, replace battery If the power light is on, but the clavicle does not respond properly, check that the battery is installed properly. Check to see that your vehicle and transmitter are on the same frequency and are set to the same band carol, range is short, fully extend the antenna. Check the battery. Try a different may be interference from focal sources.