BEFORE YOU PROCEED READ THE DITHER'S MANUAL SAFETY PRECAUTIONS SUPPLIED EQUIPMENT TOOLS AND BATTERIES YOUR RT-RADICAL SHYSTER THE RLS CHASSIS VESTING UP THE ANTENNA SELECT OME OF THE THREE BANDS (RED, RANGE GR GREEN] INSTALL BATTERIES ATTACHING THE BODY TO THE CHASSIS DECORATE YOUR VEHICLE BONY TIGHTEN THE WHEELS OK YOUR VESICLE SETTING THE TRANSMITTER AND CAR BARD PER-RUN ROUT HIE RANGE TEST YOUR VEHICLE RUNNING YOUR VEHICLE TUNING YOUR VEHICLE MAINTAINING YOUR WRIGLEY REPAIRING AD REPLACING WORM GR BROKEN
Reline RC wants you io enjoy your new vehicle and to operate It with care and safety. Failure to operate your vehicle in a safe and responsible manner may result in injury to yourself, others or property around you. You are responsible for following the guidelines mentioned here and to operate your vehicle safely. +6 not sun your vehicle on public roads or any area where you may interrupt pedestrian or vehicle traffic. + Do not operate in & congested area or in crowds.
Your vesicle is equipped with an RT-1 Radio Shyster. The RT-1 Radio System is a 2-channel, 3-Band system that operates on either Mhz radio frequency. The frequency your transmitting operates on is clearly marked on its back {controller}. The 27 MHZ / 48 MHz frequency is divided into one of three bands: Red, Orange or Green.
The steering wise! allows you 10 steer your vehicle eft and right. The steering radius control knob located on the face of your transmitter allows you to select the radius of your tums. Moving the knob fo the deft increases the fuming radius and is designed for novice ‘drivers. Moving the knob to the right decreases the turning radius and is designed for experienced drivers. 4 Located on the face of your transmitter, you can adjust § the torque or speed of acceleration will this switch.
Always tun on your transmitter before turning on your car, as your car could be effected by outside radio signals f your transmitter is not on and properly functioning. Your transmitter uses one 9-Volt battery.
You must install the antenna mast (tbe) before you operate your vehicle. Locate the antenna wire that is fixed to the receiver. Straighten the wire, then insert the end of it into ane end of the antenna tubs. Push the wire all the way through. & may extend through the length of the tube. Do not cut the wire, 8s its length is tuned to the frequency. insert the base of the. ube into the molded post on the chassis. Hold the antenna tube at the bottom of tha tubs. Do not push from the top.
Hi Your vehicle runs on either 27 Mhz or 49 Miz as was preset at the factory. You cannot change the frequency. Your car also suns on one of three bands that you can change, and allows you io race three cars with the same frequency at once without one interfering with the otters. You can race against any vehicle that fs running on a different frequency from yours without concern for interference.
Guide the antenna through the antenna hole in the car body. Warpath Set the car body over the fours posts on Whe chassis.
The decals ase printed on self-adhesive label stock. Gently remove the fables from the backing and place one edge in the proper position on the tar body, Gently smooth the decal down with your finger. This process of mouthing from cre side to the other will prevent air bubbles under the label.
RTE The wheels an your fricative can be removed and of replaced. They should be properly secured out of the box, however iris a good idea to confirm your wheels are properly attached 16 the chassis, Place the chassis on a Hat service on its four wheels. Now hold one wheel sa it does not turn, and, using the Philips head screwdriver provided, gently um the screw located in the center of the wheel clockwise 10 tighten. This should be done slowly and gently---D NOT FORCE.
Your vehicle came with a preinstalled pinion gear. This (10 tooth) gear is designed for ail surface running. If you want more lop end speed and can accept sower acceleration and you are planning fo run on hard, smooth surfaces, you may want to install the included larger pinion gear (11 tooth}. This larger pinion gear is not intended for rough terrain.
All the replacement pairs for your vehicle are available Prom your local lobby dealer or trim Radii RC. Please remove ths exploded view of your vehicle below Io assist irs the repair and or identification of parts required.
TE HEE pen ait 205 chess STEERING GC THO. H {ws jig jag org ms ge Ne BEF Renee frat a Ta FRE spr, Bes ied ary EE Sg i rove we COVER re id ren BET goes SHE OAZ500 “sacra.
Radio System Is not working properly if power light does not come on or is not bright, replace battery if the power fight is or, but the vehicle does not respond properly, check that the battery is installed property. Check to see that your vehicle and transmitter are on the same frequency and are set to the same band color. H range is short, fully extend the antenna. Check the battery. Try a different location---there may be Interference from local sources.