User Manual

-7-
2) Receive Mode(PTT Switch Not Depressed)
-. Continuous Green(5 Seconds) : Channel monitor active
-. Flashing Pink : Selective Call or Call alert present
-. Flashing Green : with carrier, Incorrect Tone Detect.
3) PC to LMR Programming Down-Loading
-. Flashing Green : Down-Loading Active
4) LMR to PC Programming UP-Loading
-. Flashing RED : UP-Loading Active
5) LMR to LMR Cloning
-. Flashing RED : UP-Loading Active
-. Flashing Green : Down-Loading Active
2.12 TIME-OUT-TIMER(T.O.T) (PROGRAMMABLE)
TheT.O.TFeatureendsatransmissionwhichisover60secondsinlength.after time out,
a continuous alert tone sounds until The PTT switch is released.
2.13 CHANNEL SCAN
To initiate the scan feature, Rotate the channel selector to the location with the scan list
programmed to it.
1) Non priority channel scan
2) Priority channel scan
2.14 DEFINITION OF PRIORITY CHANNEL
-. Only one priority channel.
-. Parameter format is designated by pc program.
-. Priority channel is always selection by pc program.
-. Home channel is also designated by pc program.
-. Methods of priority scan
Priority scan is proceeded as follows ;
CH#1 PCH CH#2 PCH CH#3 ..... PCH CH#N
2.15 POWER SAVING MODE
1) Power saving mode operation by the following conditions.
-. Only if the receive mode does not have the carrier, Power saving mode is on.
But it is off in the scan mode.
-. NO Carrier.
-. Power saving mode is designated by PC program.