User's Manual

5.17 Set Password

Set Password is to prevent the other people from using the radio by setting a password. The user should type in the

correct password to use the radio.

① Enter into Menu mode.

② Select “Secret” by pressing Channel buttons (▲ and ▼) and press “Menu” button. Then, “New Password”

will be displayed. Or if the user had set the password already, Password will be displayed. The user can set a

password in maximum 6 digits by using four buttons(▲, ▼, PTT, Menu)

③ When the user presses a button, “8” will be displayed. After pressing the password, press Monitor button on

left side of the radio. If the password is of 6 digits, the user must press “PTT” button after pressing the

password.

④ If “Confirm the password” is displayed, type in the new password again. If the users types in a wrong password,

“Error” will be displayed and user’s password input will be cancelled.

⑤ If the user had set the password, the user can change the password only after typing in the correct password.

⑥ When “New Password” is displayed while the user is trying to delete the password, press “PTT” button on left

side of the radio twice.

⑦ Exit Menu mode by pressing “M” button after typing in the password.

☞Caution) If the user forgot the password, the user cannot use the radio and need to contact the service center of

Unimo. Do not forget the password.

5.18 Forbid Tx

Forbid Tx is to forbid transmission forcefully and allow the radio only to receive calls.

① Enter into Menu mode.

② Select “Forbid” by pressing Channel buttons (▲ and ▼) and press “Menu” button

③ Select the status – On or Off – by pressing Channel buttons (▲ and ▼).

5.19 Set VOX

Set VOX is to enable users to make transmission for VOX without pressing PTT button. (This function could be

available with Ear Mic [External VOX]).

① Enter into Menu mode.

② Select “VOX” by pressing Channel buttons (▲ and ▼) and press “Menu”. Then, two menus – VOX and

Sense – will be displayed.

③ Select “VOX” by pressing Channel buttons (▲ and ▼). Press “Menu” button. Then, the user can decide

whether to turn on the VOX mode or not. Select “On” by pressing Channel buttons (▲ and ▼). Then, the

menu by pressing “Menu” . exit “M” buttons. The radio transceiver will operate in the VOX mode.

④ To set the VOX sensitivity, enter into Menu mode and select “Sense”. Then, select the VOX sensitivity by

pressing Channel buttons, and then, the menu by pressing “Menu” . exit “M” buttons.