User's Manual

Maintenance Manual
23
with ”beep” sound.
BCL/BCLO
BCL/BCLO function is used not to interrupt the other users who are using the same frequency. If
BCL/BCLO is activated then transmitting is prohibited from the same channel that was used for others. In
this case, alert sound is heard.
BCL(Busy Channel Lock) : Prohibit transmission from the same frequency.
BCLO(Busy Channel Lock Override) : Prohibit transmission in case of different sub-tone.
TOT
TOT function is used to prevent from using one channel continuously for a long time. If the radio
transmits over the TOT time continuously, the transmitting is automatically stopped and an alert sound is
generated. If a Penalty time is set up then the radio makes transmitting normally after the penalty time.
The TOT and penalty time can be setup by PC programmer.
Key Lock
Press buttons over 2 seconds then Key Lock is activated when the radio is standby mode. The buttons
doesn’t operate during this function is activated except PTT and this button. Key Lock function can be
deactivated, pressing the pre-assigned button once more when the Key Lock is activated.
Battery Indication
Press the pre-assigned button when the radio is standby mode. The pre-assigned color of LED is turned
ON for one second.
 Green color : full charged
 Yellow color : sufficient
 Red color : Requires charging
 Red color of LED is blinked : The radio is turned OFF
PSC
It can be increased the battery lifetime when the PSC function is activated. It can be changed on the PC
programmer.