User's Manual

AC-2100 Plus 사용자 가이드 34
UNIONCOMMUNITY Co., Ltd. / 12F, Daemyung Valeon, 127, Beobwon-ro,
Songpa-gu, Seoul, 05836, Republic of Korea
TEL: [phone] / FAX: [phone] E-Mail :[e-mail]
http://www.unioncomm.co.kr
This menu is to determine the authentication priority between the terminal and the network, the
default is ‘2. SN’, and the authentication method in each mode operates as follows.
NS
If the terminal is connected to the server, authentication is attempted from the server. If
the terminal is disconnected from the server due to a network failure, etc.,
authentication is attempted from the terminal.
SN
Even if the terminal is connected to the server, authentication is attempted from the
terminal. The authentication result is sent to the server in real time.
However, if the entered user is not registered in the terminal, authentication is
attempted from the server. (If there is any fingerprint user in the terminal, the 1:N
fingerprint authentication is not performed in the server.)
NO
Even if the user is registered in the terminal server, authentication is performed
through the server only.
SO
Only users registered in the terminal are authenticated. If the terminal is connected to
the server, the authentication result is sent to the server in real time.
The authentication priority may be set flexibly depending on the situation such as the number of
terminals connected to the server, the number of authenticated users, or network failure.
However, if more than 10 terminals are connected to the server and so concurrent authentication
is often attempted, or if network failure often occurs, it is recommended to attempt SN
authentication (set to ‘2’).
After entering correctly, press [ENT] button, and the screen will go to the upper menu.