User's Manual

AC-5000 / 5100 User Guide 21
UNIONCOMMUNITY Co., Ltd. / 12F, Daemyung Valeon, 127, Beobwon-ro,
Songpa-gu, Seoul, 05836, Republic of Korea
TEL: [phone] / FAX: [phone] E-Mail :[e-mail]
http://www.unioncomm.co.kr
This is the way to access the menu if fingerprint authentication is impossible, or
because the user forgot the admin password, or lost the card registered on the
terminal, or there is no Admin.
① Remove the bracket on the rear of the terminal to open the lid.
② With the lid open, as shown in the figure below, connect pin 1 to pin 3, and pin 2 to
pin 4 of connector J404.
<Figure 3-3>
③ Access the menu by pressing and holding the [F4(←)] key for 2 seconds or longer.
Enter Admin ID as ‘0’ on the Verify Admin screen <Figure 3-2>, and press the [ENT]
key. The user can now access the menu selected and the buzzer sounds “Brrrrrrp”.
▶ After modifying the configuration, remember to remove the wires from the
connected pins on the J404 connector.
3.1.3. Modify Set Values
The following are the names and input methods for setting items.
<Figure 3-4>
①Input Box (with highlight)
①Input Box (without highlight)
②Select Button
③Check Box