User's Manual

AC-5000 / 5100 User Guide 30
UNIONCOMMUNITY Co., Ltd. / 12F, Daemyung Valeon, 127, Beobwon-ro,
Songpa-gu, Seoul, 05836, Republic of Korea
TEL: [phone] / FAX: [phone] E-Mail :[e-mail]
http://www.unioncomm.co.kr
Press the [F4 (←)] key to delete the existing value,
enter the authentication method you want to use
among the authentication methods shown on the
screen, and press the [ENT] key.
If you select [AND] mode, authentication will proceed
normally with the authentication method.
(Priority: Card -> Fingerprint -> Password)
When selecting [OR] mode, only two authentication
types can be selected.
※ If you do not set the authentication method after registering the card, it is necessary
to be careful when registering because it is not possible to search DB when
registering existing card as a new user.
3.3.1.2. FP Register
① Place finger on the sensor - refer to ‘1.8. How
to register and enter fingerprint ‘. Fingerprint must be
input twice, as below, according to the screen
guidance.
When the fingerprint sensor is lit and the message
“Place Finger on sensor” is displayed, place a finger
on the window for fingerprint input - for 2~3 seconds
- until the light goes off.
② When the message ‘Place same Finger on sensor
is displayed, enter the fingerprint once again.
※When entering the fingerprint for the second time,
make sure the user has taken their finger off the
fingerprint input window after the first read.
③ When input is complete, the message at the left
appears, together with the images accompanied by
their quality rating from 0~100.
If the image is not adequate from a visual aspect, or
any image shows 30 or less, the user is advised to
register again.
To register again, start the process from step ① by
pressing [F4 (←)] key until 3 seconds elapse without
input or pressing another key. After completion, the
system moves to the parent menu.
※ Fingerprint registration is available for up to 10 per ID. A failure message appears
when registration is attempted in excess of 10 times.