User's Manual

AC-5000 / 5100 User Guide 32
UNIONCOMMUNITY Co., Ltd. / 12F, Daemyung Valeon, 127, Beobwon-ro,
Songpa-gu, Seoul, 05836, Republic of Korea
TEL: [phone] / FAX: [phone] E-Mail :[e-mail]
http://www.unioncomm.co.kr
▶’1:1 Level’ (Initial setting: ‘0’)
Is the item that determines the authentication level
for each registered user. By modifying this value, it
is possible to determine the authentication level per
registered user.
When set to ‘0’, it conducts authentication using
the 1:1 authentication level of the terminal.
▶Enable 1:N (Initial setting: ‘v’)
When this option is checked, it’s possible to
successfully authenticate using a fingerprint
without any user ID or card.
3.3.1.6. Save
When the registration process is complete, press [Ent] key to save it. The user settings
are not saved if the user doesn’t press [Ent] key and exits by pressing the [F4 (←)] key.
The following is the LCD guidance message indicating the user can exit from the
registration process.
When registered normally with [ENT] key pressed.
When registration failed after [6. Save] key pressed.
Means the user is not registered properly in accordance
with the authentication method. For example, the user
didn’t register any fingerprint after setting it as the
authentication method, nor registered a card after
setting it as the authentication method.
In the case of [2. FP Register]
When fingerprint image is not in a good condition or
there is no fingerprint input within 10 seconds of the
fingerprint sensor lamp being on.
At the time of fingerprint registration, when the user
didn’t input the same finger, but input a different finger.