User's Manual

AC-5000 / 5100 User Guide 38
UNIONCOMMUNITY Co., Ltd. / 12F, Daemyung Valeon, 127, Beobwon-ro,
Songpa-gu, Seoul, 05836, Republic of Korea
TEL: [phone] / FAX: [phone] E-Mail :[e-mail]
http://www.unioncomm.co.kr
Set DDNS ID, DDNS IP and server port.
DDNS ID can be input from 9 digits
1 to 999999999 can be input.
The default value of DDNS IP is 210.116.104.058,
and enter the IP of DDNS server to be connected.
To change the port, press the [ENT] key to move the
input focus to the server port and enter it.
▶Initial Setting
Server Port: ‘9870’
The default port value of the authentication server is '9870' for the UNIS server and
'2201' for the Access server. Special care should be taken since if you change this value,
you must change it to the same value in the server program.
After finishing the setting, press [ENT~] key to apply the changed value, or press [F4
(←) ~] key to exit the parent menu.
3.4.3. Terminal ID
Select ◆ [ENT~] [2. Network] [3. Terminal ID] on the initial screen ◆, and the
following screen appears:
Set Terminal ID and Authentication.
▶Initial setting
Terminal ID: ‘1’
Authentication: ‘2. terminal/server’
Terminal ID is the unique ID used by the authentication server for the purpose of
identifying the terminal having ‘1’ as its default value. It must correspond to the
entry/exit door ID set in the server program - which can be input as a maximum of 8
digits.
▶ Authentication
This determines the priority for authentication between terminal and the network server.
Having ‘2. Terminal/Server’ as its default value, operation is as follows in each mode:
1.
Server/Terminal
Authentication is made by the server when it’s connected to the network,
and by the terminal when it is disconnected from the server due to
network disturbance, etc.