User's Manual

AC-5000 / 5100 User Guide 39
UNIONCOMMUNITY Co., Ltd. / 12F, Daemyung Valeon, 127, Beobwon-ro,
Songpa-gu, Seoul, 05836, Republic of Korea
TEL: [phone] / FAX: [phone] E-Mail :[e-mail]
http://www.unioncomm.co.kr
2.
Terminal/Server
Authentication is made by the terminal, even if the server is connected,
and authentication result transferred to the server on a real-time basis.
3. Server Only
However, authentication is made by the server when the input user ID or
card is not registered in the terminal (it doesn’t attempt server
authentication in case of 1:N fingerprint authentication).
4.
Terminal Only
Although the user is registered in the terminal, authentication is made via
the server. Therefore, authentication cannot be performed unless the
server is connected.
Flexible designation is allowed depending on the circumstance, such as the number of
terminals connected to the server, the number of users authenticated, or network errors
etc. It is recommended to use ‘2. Terminal/Server’ so concurrent authentications can be
attempted if 10> terminals are connected to the server, or if frequent network errors
occur.
※ In the server authentication mode, logs are stored in the server, not the terminal.
3.5. Application
Selecting ‘3. Application’ in the main menu causes the following screen to appear:
Press the applicable key representing the item to be
changed.
3.5.1. Application
Select ◆ [ENT~]  [3. Application]  [1. Application] in the initial screen ◆, and the
following screen appears:
Select the terminal operation type by pressing the
applicable numeric key.
Press the [ENT] key to apply the configuration and
[F4 (←)] key to cancel it.