User's Guide

UBio-X Iris User Guide 57
UNIONCOMMUNITY Co., Ltd.
Addr : 12F, Munjeong Daemyeong Valeon bldg, 127 Beobwon-ro Songpa-gu,
Seoul, Korea (zip code: 05836)
Tel: [phone], Fax: [phone],
E-Mail :[e-mail]; http://www.unioncomm.co.kr
▶Lock 1 Option
- None: When it is not used
- Strike/Auto/OK: When the warning light is connected to indicate the strike type,
auto door, or authentication success/failure on Lock1.
- Motor Lock 1: When the motor lock is connected.
- Schedule alarm: When the siren setting of the terminal option was sent to the
terminal, it sends the operating signal about it.
- Duress alarm: When the fingerprint registered as a duress FP is authenticated
▶Lock2 Option
- None: When it is not used
- Fail: When connecting the light to Lock 2 to indicate the authentication failure
- Motor Lock 2: When connecting the motor lock
- Schedule alarm: When the siren setting of the terminal option is sent to the
terminal, it sends the operating signal about it.
- Duress: When authenticating with the duress fingerprint
▶Lock 1 duration (ms)
When Lock 1 is set ‘Strike/Auto/OK’, it determines the signaling time. Because it is set
in ms unit, if you want to set 3 seconds, you should set 3000. The strike type means
the time until the door is locked again when opening the door after authentication.
▶Lock 2 duration (ms)
It sets the signaling time when Lock 2 is set ‘Authentication failure notification’.
Click [OK] button to apply the set value, and click [BACK] button to cancel and return.
Because it is set in ms unit, if you want to set 3 seconds, you should set 3000.
3.7.5. External Device
If you select the [Terminal]  [External device] in the main menu, the following
window appears.
▶Basic setting : Same with the window at
the left side
▶RS232: It sets the device connected to RS232 port
-None: When there is no device connected to the RS232 port
-Ticket Format 1/ Ticket Format 2: The authentication result is printed when the
authentication is successful. The terminal ID, user ID, authentication time, and