User's Manual

Installing Batteries
In the Transmitter
The transmitter requires one 9-volt battery (not included).
1. Slide open battery door and place the battery in the transmitter as indicated by the
polarity symbols ( + and - ) marked inside.
2. Slide battery door all the way closed.
In the truck
You can use7.2V battery pack (not included) for the truck.
1. Make sure the truck is turned Off.
2. Turn compartment latches on the bottom of the vehicle toward open.
3. Lift the battery door open.
4. Insert a fully charged 7.2V battery pack
5. Attach the connector of the battery pack with the truck’s connector.
6. Replace the battery door and turn the latches closed
Battery Note:
- Dispose of old batteries promptly and properly.
- Do not dispose of batteries in a fire.
- Do not mix old and new batteries or batteries of different types: alkaline, standard
(carbon-zinc) or rechargeable (nickel-cadmium).
- Remove batteries during long periods of non-use. Always remove exhausted
batteries from the toy.
Operating the truck
1. Extend the antenna of transmitter to its full length.
2. Slide ON/OFF switch of transmitter and truck to ON.
3. Steering Wheel - Use the steering wheel to turn left and right. Release to drive