EXTENSION TABLE CAUTION: You must read this before you proceed CAUTION: This Table is NOT a TOY. Keep your child / children at bay in the process of assembly. For turning the Table and to prevent damage to the Table, 02 persons may be needed to execute this action.
Label Picture Description Table Top A Qty 1 B Expansion Board of Table Top 1 C Leg 4 Description Qty No.
Before Beginning Assembly: OVERVIEW Table Top (A) Expansion Board of Table Top (B) FRONT FACING Leg (C) This Table has multiple parts and may require up to some 30 minutes to assemble. To give you an overview of the Table, the above picture to assemble to help you put the various parts into perspective. Please read through the instructions here below to familiarise the parts and steps before assembly.
Step 1 Unpack and place all parts on a clean non-marring surface. With assistance from your adult partner, Carefully place the Table Top (A) with Expansion Board of Table Top (B) face down. Step 2 Put the Expansion Board of Table Top (B) into the Table Top (A) Then, secure Expansion Board of Table Top (B) with Table Top (A) by using 2 Screws (④)+ Allen Key (①) as designated points as picture above.
Step 3 Attach one of Legs (C) to Table Top (A) by using 2 Bolts (②), 2 Washers (③) and Allen Key (①). Repeat the same step for 3 remaining legs (C). Step 4 With assistance of your adult partner, carefully stand the Table up. EXERT pressure, floorwards, onto the Table. This pressure will help the Legs and Table Top reach alignment at all joints. Check for wobbles. In a sequential manner, gradually tighten all Bolts until evenly secured. Inspect the Table and make sure all parts are adequately connected.
Extension Steps: To Extend the Table Step 1 Gently pull the Table Top (A) outwards to open and stop when it could see the extension board frame support. Caution: Do not Lean on or apply pressure to the table when it is pulled open. This could cause damage to the product. Step 2 2.1 2.2 2.1) Turn the Expansion Board of Table Top (B), located inside of the table as shown above. 2.2) Push the Table Top (A) inwards until the Top Table (A) fits in the Expansion Board of Table Top (B).
Step 3 Lock the Metal Fastener under the table to lock the Expansion Board of Table Top (B) into place. Your Table is extended and is now ready for use. Extension Steps: To Retract the Table Step 1 Unlock the Metal Fastener before retracting.
Step 2 2.1 2.2 2.1) Gently pull theTop Table (A) outwards to open and stop when it could see the extension board frame support. 2.2) Turn the Expansion Board of Table Top, located inside of the table as shown above. Caution: Do not Lean on or apply pressure to the table when it is pulled open. This could cause damage to the product. Step 3 Push the Table Top (A) inwards until two wings of Table Top (A) align.
