Installation & Assembly

Tools: #2 Philips or Robertson driver & hammer (nail gun optional)

Before Assembly: Please check all components with content list

STEP 1. Assemble Planter Sides

• Insert 6x Side Slats (A) into slot in Rail (C)

• Slide a 2

Rail (C) over free end of slats

• Repeat above directions to assemble other 3 sides

NOTE: tight fitting slats can be eased by rubbing ends with candle wax

STEP 2. Attach Planter Posts

• Stand planter side, centered, between 2x Posts (D)

• Put 2x spacer blocks under planter side to create bottom spacing as illustrated

• Attach posts using 4-inch screws

Note: posts have 2 heights of pre-drilled holes when viewed from each side. Position

posts so that holes are at identical height when viewed from front

• Repeat Step 2 for 2

set of posts

Package Contents:

(A) Side Slat… 24 (short slats)

(B) Bottom Slat… 6 (long slats)

(D) Posts… 4

(E) Horizontal Slats…8

(F) Pre-drilled Horizontal Slat …1

(G) Vertical Slats …4

(H) Pre-drilled Vertical Slats…4

Hardware

• 4” screw… 16

• 1 ¼” Screw…7

• ½” Wood Spacer Block… 2

• Trellis Nailing Strips…2

• Nail…80

20" Planter Box with Trellis

PAGE 1
20" Planter Box with Trellis Tools: #2 Philips or Robertson driver & hammer (nail gun optional) Before Assembly: Please check all components with content list Package Contents: (A) Side Slat… 24 (short slats) (B) Bottom Slat… 6 (long slats) (C) Rails… 8 (D) Posts… 4 (E) Horizontal Slats…8 (F) Pre-drilled Horizontal Slat …1 (G) Vertical Slats …4 (H) Pre-drilled Vertical Slats…4 Hardware • • 4” screw… 16 1 ¼” Screw…7 • ½” Wood Spacer Block… 2 • • Trellis Nailing Strips…2 Nail…80 STEP 1.
PAGE 2
STEP 3. Assemble Planter Box • Form a corner by centering side assembly to open face on post • Attach side assembly to post using 4-inch screws • Repeat for other side STEP 4. Insert Planter Bottom • Set 6x Bottom Slats (B) into the planter so ends rest on the inside lower rail lip Note: no attachment is required • A small gap will remain along inside lip for water drainage Step 5.