Owner Manual - Dining Chair

ManualsBrandsUnion Rustic ManualsOutdoor & Patio FurnitureVictorine Outdoor 7 Piece Dining Set with Cushions

CAUTION: This Chair is NOT a TOY.

Keep your child / children at bay during the assembly process.

For moving the Chair and to prevent damage to the Chair, two adults are

needed to execute this action.

Caution : You must read this before you proceed

DINING CHAIR

Page 1 of 7

Please look in the

eft

eg for hardware packs.

Summary of content (7 pages)

PAGE 1
Caution : You must read this before you proceed Please look in the left leg for hardware packs. DINING CHAIR CAUTION: This Chair is NOT a TOY. Keep your child / children at bay during the assembly process. For moving the Chair and to prevent damage to the Chair, two adults are needed to execute this action.
PAGE 2
Label Picture Description QTY A Left Leg 1 B Right Leg 1 C Backrest 1 D Seat Panel 1 E Seat Cushion 1 Label Picture Description QTY 1 Screw (M6x45mm) 7 2 Bolt (M6x40mm) 3 3 Sleeve Nut (M6x13mm) 3 4 Allen Key 2 Page 2 of 7
PAGE 3
Before Beginning Assembly: OVERVIEW Backrest (C) Right Leg (B) Seat Cushion (E) Left Leg (A) Seat Panel (D) FRONT FACING This Chair has multiple parts and may require up to some 30 minutes to assemble. To give you an overview of the Chair parts, the above picture is to help you put the various parts into perspective. Please read through the instructions below to familiarise yourself with the parts and steps before assembly.
PAGE 4
Step 1 Unpack and place all parts on a clean, non-marring surface. Step 2 4 B Step 2.1 4 Step 2.2 2 1 3 4 D 2.1) Position Right Leg(B) and Seat Panel(D) as shown in picture above. Secure Right Leg(B) and Seat Panel(D) using Screw(①) with Allen Key(④). 2.2) Secure Right Leg(B) and Seat Panel(D) using Bolt(②), and Sleeve Nut(③) ③ with Allen Key(④). ④ Only loosely tighten the Screws and Bolts.
PAGE 5
Step 3 4 A 4 1 2 3 4 With the help of your partner, turn the Chair over and rest on Right Leg(B). Repeat the same process from the previous step to attach the Left Leg(A). Only loosely tighten the Screws and Bolts. Step 4 C 1 4 Place Backrest(C) into the housing of Left Leg(A) and Right Leg(B) You may need to apply a little pressure to the Legs, pushing outwards, to enable the Backrest(C) to be slotted into position.
PAGE 6
Step 5 If wobble Test again 30CM~50CM Place the Chair right side up on a LEVEL SURFACE to see if it wobbles. If it wobbles, lift the Chair to some 30cm to 50cm height from the ground. Keep your feet and toes well away from the drop zone. Drop the Chair freely and vertically with the four legs, hitting the ground, at the same time. This Drop Test will help to ensure that all the Bolts, Screws and gaps all reach full alignment status. Test again for evenness on a LEVEL SURFACE.
PAGE 7
Page 7 of 7