Installation & Assembly

For your convenience we use Recex multi-drive, rust-resistant zinc plated hardware.

You will need a #2 Philips or Robertson driver, wood glue & a hammer. (Staple/Nail gun optional)

Step 1. Build Frame

• Arrange 2 X-Members between 2 posts and fasten

together using 2-½ inch screws.

• Lower x-member should be attached 7 inches up from

bottom of posts as shown.

Step 2. Arrange Vertical Lath

• Inside the frame lay out 3 shorter lath (B) between 2 longer lath (A).

• Use spacer blocks to attain a uniform distance between all vertical lath.

Package Contents:

(A) Vertical Lath… 4

(B) Vertical Lath… 6

(D) Nailing Strips… 8

(E) Spacer Block… 4

(F) Posts… 4

(G) X-Member… 4

Hardware:

• 2-½" Screw… 16

• ¾" Nail… 220

• 1-½” Nail… 64

• Hinge Set… 1

Trellis Screen

Note: A stapler or nail gun can be used as an alternative to join the slats together.

(Unassembled kit)

PAGE 1
Trellis Screen (Unassembled kit) For your convenience we use Recex multi-drive, rust-resistant zinc plated hardware. You will need a #2 Philips or Robertson driver, wood glue & a hammer.
PAGE 2
Step 3. Attach Horizontal Slats • • • • Set 11 horizontal slats (C) across vertical lath. Use spacer blocks to attain a uniform distance between horizontal slats. Apply a dab of wood glue to strengthen each join – do not nail into place until all 11 slats have been positioned. Once you are satisfied with the arrangement, use ¾ inch nails or staple gun to tack lattice together. (use 2 nails per join) Step 4.