Caution : You must read this before you proceed SUNLOUNGER CAUTION: This Sunlounger is NOT a TOY. Keep your child / children at bay in the process of assembly. For turning the Sunlounger and to prevent damage to the Sunlounger, 02 persons may be needed to execute this action.
Label Description QTY A Seat Panel 1 B Back Leg Panel 1 C Left Front Leg 1 D Right Front Leg 1 E Leg Support Bar 1 F Wheel 2 Description QTY ① Bolt (M6x40mm) 5 ② Bolt (M8x55mm) 3 ③ Bolt (M6x25mm) 5 ④ Screw (M6x60mm) 3 ⑤ Washer (M8x20x2mm) 3 ⑥ Washer (M8x20x5mm) 3 ⑦ Sleeve Nut (M8x15mm) 3 ⑧ Iron tube for Wheel (M8x10x26mm) 3 ⑨ Allen Key 2 Label Picture Picture 2
Before Beginning Assembly: Overview This Sunlounger has multiple parts and may require up to 30 minutes to assemble. To give you an overview of the Sunlounger parts, the above picture is to help you put the various parts into perspective. Please read through the instructions below to familiarise yourself with the parts and steps before assembly.
Step 1 Unpack and place all parts on a clean, non-marring surface. Step 2 Place Seat Panel(A) facedown on a clean, non-marring surface. Position the Back Leg Panel (B) to Seat Panel (A) as pictured above by using Bolts (③) with Allen Key (⑨). Do not fully tighten the Bolts. Caution: At the same time, please don't place your hands between the gaps to avoid injury. Step 3 E C D Attach Left Front Leg (C) to Leg Support Bar (E) by using Screws (④) with Allen Key (⑨).
Step 4 C E A D Attach the Pre-assembled in step 3 to Seat Panel (A) by using Bolts (①) with Allen Key (⑨). Do not fully tighten the Bolts. Step 5 F B Attach one of Wheel (F) to Back Leg Panel (B) by using Bolt (②), Washer (⑤), Iron tube for Wheel (⑧), Washer (⑥) and Sleeve Nut (⑦) with Allen Key (⑨) in sequence as shown on the picture above. Then, repeat the same process of this step to attach the other Wheel (F) to the remaining Back Leg Panel (B). Do not fully tighten the Bolts.
Step 6 6.1 6.2 Carefully sit onto the Sunlounger. This pressure will help the Sunlounger reach full alignment at all joints. In a sequential manner, gradually tighten all Bolts and Screws until evenly secured. Inspect the Sunlounger and make sure all parts are adequately connected. Your Sunlounger is ready for use. This Sunlounger can only be used on a flat, level surface. Note: 6.1) Align the Backrest of Sunlounger in position you want 6.
