Specifications

6. Advanced use
57
Code name registration performance with front panel keys
Input code names by using numeral keys from [1] to [0], and [-(ST)], [SP(GT)],
[(DEL)] keys. Since each numerical key is assigned approx. 10 characters, press the key until a
desired character is displayed results. (This is designateed a key group.) For the list of characters
assigned to each group, see the appendix "Character input table"(page 83).
- For inputting a character in the same group successively, press [DEL] once to move
the virtual cursor one character ahead.
- For inputting a character in a different group, input it successively. It is not necessary to
press [DEL].
The basic operating procedures for actually setting the M252A actually are described below. Here, the
code name "ABCDE" is registered to Ach as an example.
1. Press [A] → [ENT], and the following is printed to start
code name input.
2. Input the code name as follows.
3. The registered code name is printed.
>> Input Code A - ENT
>> Now Code A [ABC ]
operating
A
B
C
D
E
Press
Ａ
Virtual cursor position
three times.
Ａ
Ｂ
two times. ＡＢＣ
three times.
ＡＢＣＤ
(Actually, it is
ＡＢＣＤＥ
four times.
Upon completion of input, fix with
two times.
Press
Press
Press
Press
not indicated.)
>> Code name is [ABCDE ]