Installation Guide
UGP-6C/8C/10C
NOTE: The direction in which your refrigerator doors open (door swing) can be reversed, from left to right
or right to left, by moving the door hinges from one side to the other. Reversing the door swing should be
performed by a qualifi ed person.
1. Remove top hinge cover.
2. Remove top hinge with Phillips screwdriver and lift freezer door o of center hinge and set door aside.
3. Unscrew center hinge with Phillips screwdriver.
4. Lift refrigerator door o of bottom hinge and set aside.
5. Remove bottom hinge with Phillips screwdriver.
6. Now remove all plugs and caps from opposite side and place them in the holes you just remove the
screws from.
7. Using a Phillips screwdriver fasten the bottom hinge in place using the screws you previously removed.
8. Place fridge door on bottom hinge, then place middle hinge in top hole of fridge door and using the
Phillips screwdriver, fasten the middle hinge in place using the screws you previously removed.
9. Now place the freezer door on top of the middle hinge, then place top hinge in top hole of the freezer
door and using the Phillips screwdriver, fasten the top hinge in place using the screws you previously
removed.
10. Tighten all screws while making adjustments where necessary to ensure they are aligned correctly and
closing well against the cabinet, this will reduce any excessive frost build up.
UGP-19C DOOR REVERSAL INSTRUCTIONS
1. Open the fridge door to fi nd the accessory box, take out the left top hinge, middle hinge and bottom
hinge.
2. Lay down the refrigerator, remove the screws of the right top hinge and middle hinge in sequence using a
cross screwdriver. Unscrew center hinge with Phillips screwdriver.
3. Remove the left and right bottom feet, unscrew the four fi xing screws of the bottom plate. Remove the
bottom plate. (As shown in fi gure A)
4. Remove the three fi xing bolts of the right bottom hinge with an 8mm inner diameter open wrench or
cross screwdriver. (As shown in fi gure B)
5. Align the prepared hinge axis of the left bottom hinge to the left axle hole on the door body, then fi x the
left bottom hinge with the three fi xing bolts just removed. (As shown in fi gure C) Install the left top hinge
and left middle hinge in sequence.
6. Install the bottom plate and bottom feet.
DOOR REMOVAL & REVERSAL INSTRUCTIONS
Fig. CFig. BFig. A
IMPORTANT: After reversing the door hinge, the door gasket may be loose. Should you notice a gap between
the gasket and the cabinet, use a hairdryer or heat gun and heat the gasket while on the appliance. The
gasket will expand to meet the cabinet. Allow 30 minutes to cool before opening. A correct gasket positioning
is the key to prevent refrigerated air from escaping. Best to perform in the evening before bedtime.
15