User's Manual

Chapter 5 Operation
5 Operation
5.1 Introduction
This section addresses the control and operation of the DRU-1k and
provides descriptions of
indicators and controls.
5.2 Control and Communication
T
he DRU-1k can be controlled locally (on-site) or remotely from a Network Management
System (NMS).
5.2.1 Control and Communication Interfaces
There is one (1)
“cabinet” interface port provided for control and communication:
 TEL (Screw Terminal) – used for remote control of the HBE, LBE and TRMS via dial-
up modem and LBE.
The HBE and LBE also include a front panel RJ-45 Ethernet port for local control of the
corresponding exciter.
Please refer to the corresponding Operating Manual for detailed information on configuring the
HBE, LBE and TRMS interface ports for local or remote control.
5.2.2 User Interfaces
The HBE, LBE and TRM
S include their own user interface(s), permitting an operator to control
the device locally or remotely. Please refer to the corresponding Operating Manual for
detailed information on the HBE, LBE and TRMS user interfaces.
5.3 Modes of Operation
5.3.1 High Band Sub-system
Pleas
e refer to the HBE Operating Manual for detailed information on the HB sub-system
operating modes.
5.3.2 Low Band Sub-system
P
lease refer to the LBE Operating Manual for detailed information on the LB sub-system
operating modes.
SX03-2000
0-01-M01 5-1