User's Manual

Chapter 3 Installation
Contents
3 Installation ................................................................................ 3-1
3.1 Introduction............................................................................................ 3-1
3.2 Components/Sub-Assemblies Installed at the Factory............................ 3-1
3.3 Components/Sub-Assemblies Installed On-Site...................................... 3-3
3.4 Required Tools ........................................................................................ 3-4
3.5 Installation Overview.............................................................................. 3-5
3.6 Repeater Setup ....................................................................................... 3-7
3.6.1 Moving the Repeater Cabinets........................................................... 3-7
3.6.2 Installation Surface ........................................................................3-10
3.6.3 Repeater Cabinet Positioning............................................................3-10
3.6.4 Unpacking.....................................................................................3-12
3.7 HB Cabinet Electronics Compartment Components................................ 3-13
3.7.1 BMS 12 VDC Rectifier Module...........................................................3-15
3.7.2 High Band Exciter (HBE)..................................................................3-16
3.8 LB Cabinet Electronics Compartment Components ................................ 3-17
3.8.1 Low Band Exciter (LBE)...................................................................3-19
3.9 HB and LB Cabinet HPA Compartment Components............................... 3-20
3.9.1 HPA Compartment Pre-installation ....................................................3-23
3.9.2 High Power Amplifier (HPA) .............................................................3-25
3.9.3 Finalize HPA Installation ..................................................................3-28
3.9.4 HPA PSU 30 VDC Rectifier Module.....................................................3-28
3.10 HB Cabinet Internal Wire/Cable Connections........................................ 3-30
3.10.1 Ground and AC Connections.............................................................3-31
3.10.2 High Band Exciter (HBE)..................................................................3-32
3.11 LB Cabinet Internal Wire/Cable Connections ........................................ 3-33
3.11.1 Ground and AC Connections.............................................................3-34
3.11.2 Low Band Exciter (LBE)...................................................................3-35
3.12 External Input Signal Interfaces ........................................................... 3-38
3.12.1 HB Cabinet....................................................................................3-38
3.12.2 S-Band Antenna.............................................................................3-38
3.12.3 LB Cabinet ....................................................................................3-39
3.12.4 Ku-Band Antenna ...........................................................................3-39
3.12.5 GPS Antenna .................................................................................3-40
3.13 Communications Interfaces .................................................................. 3-40
3.13.1 PSTN Phone Line ............................................................................3-40
3.14 Shelter/Room Alarm Connections ......................................................... 3-42
3.15 RF Output Interfaces............................................................................. 3-44
3.15.1 Configuration.................................................................................3-44
3.15.2 Terminating a WR3 40 Flange Output................................................3-45
3.15.3 Terminating a 7/8” EIA Flange Output ...............................................3-45
3.16 AC Power............................................................................................... 3-47
3.16.1 General Requirements.....................................................................3-47
3.16.2 Repeater Cabinet Ground Connection ................................................3-47
3.16.3 Repeater Cabinet AC Power Connection .............................................3-49
SX03-2000
0-01-M01 3-1