User's Manual

Chapter 3 Installation
3 Installation
3.1 Introduction
T
his section describes the installation procedures for the DRU-1k, which is to be installed in
a restricted access location.
3.2 Components/Sub-Assemblies Installed at the Factory
T
he following components/sub-assemblies are installed in the Combined DRU cabinets prior
to shipping.
Table 3-1 Combined DRU Components/Sub-Assemblies Installed at the Factory
Electronics Compartment Part Number Quantity
HB PDU SX03-21300-01 1 (HB Cabinet)
LB PDU SX03-22300-01 1 (LB Cabinet)
Dual Band Pass Filter (DBPF) SX03-50100-01 1 (HB Cabinet)
Low Noise Amplifier (LNA) SX03-50200-01 1 (HB Cabinet)
BMS Mounting Shelf w/Controller SX03-50300-01 1 (HB Cabinet)
BMS 12 VDC Battery SX03-50330-01 1 (HB Cabinet)
Air-to-Air Heat Exchanger/Heater SX03-50400-01 2 (1 per cabinet)
Transmission Sub-system Controller (TSC) SX03-50700-01 2 (1 per cabinet)
LBD DR Filter SX03-51100-01 1 (LB cabinet)
Break Out Board SX03-92020-01 2 (1 per cabinet)
TRMS N/A 1 (LB Cabinet)
HPA Compartment Part Number Quantity
4-Way Splitter 000087234R 2 (1 per cabinet)
4-Way Hybrid Combiner w/Loads SX03-21825-01 2 (1 per cabinet)
Fan (Blower) Box SX03-50500-01 4 (2 per cabinet)
WG WR340 Coupler/RF Detector SX03-51600-01 2 (1 per cabinet)
HPA PSU Mounting Shelf SX03-51710-01 4 (2 per cabinet)
Output Filter Network (OFN) Cabinet Part Number Quantity
Combined OFN, WG SX03-24100-02 1
WG WR340 Coupler/RF Detector SX03-51600-01 1
SX03-2000
0-01-M01 3-1