User's Manual

Chapter 3 Installation
3.7.1 BMS 12 VDC Rectifier Module
The BMS
mounting shelf includes two (2) empty slots for the 12 VDC rectifier modules.
Please refer to Figure 3-6
, Figure 3-7 or drawings SX03-20000-02-D01 or SX03-20000-03-
D01 for the mounting position of the rectifiers.
The BMS 12 VDC rectifier modules should be installed in the following sequence:
1. Slide the first rectifier module into the left-most slot until it stops – see Figure 3-10
.
2. Secure the rectifier module to the shelf by tightening the Phillips pan head screw until
it stops. As the screw is tightened, the rectifier module will slide all the way into the
slot.
3. Slide the second rectifier module into the middle slot until it stops and repeat step 2.
Figure 3-8 12 VDC Rectifier Module Front and Rear Panel
Figure 3-9 BMS Mounting Shelf with Controller
Figure 3-10 BMS Mounting Shelf with 1 Rectifier Module Installed
1) 12 VDC Rectifier Module
2) Mounting Screw (supplied with rectifier module)
3) Empty Slot for Second 12 VDC Rectifier Module
SX03-2000
0-01-M01 3-15