User's Manual

Chapter 3 Installation
3.7.2 High Band Exciter (HBE)
The elect
ronics compartment includes a custom mounting bracket for the HBE. Please refer
to Figure 3-6
, Figure 3-7 or drawing SX03-20000-02-D01 or SX03-20000-03-D01 for the
mounting position of the HBE.
The HBE should be should be installed in the following sequence:
1. Place the HBE on the custom mounting bracket located above the BMS.
2. Secure the HBE to the custom mounting bracket by tightening the four (4) knurled
screws (2 located on either side of the HBE; 1 near the front of the HBE and 1 near the
back of the HBE) – see Figure 3-12
.
Figure 3-11 HBE Mounting Bracket
PICTURE TBD
Figure 3-12 HBE Mounting Bracket with HBE
1) HBE Mounting Bracket
2) Knurled Screw
3) HBE
SX03-2000
0-01-M01 3-16