User's Manual

Chapter 3 Installation
3.10.2 High Band Exciter (HBE)
During the
installation procedure, a number of wires/cables must be connected to the HBE
rear panel. Please refer to Table 3-6
or drawing SX03-21900-02-D06.
The cables should be connected in the order that they appear in Table 3-6
.
Any RF cable, which is terminated with a SMA connector, should be
tightened with a 5/16” torque wrench to avoid over tightening and
damaging the cable connector or mating connector.
Figure 3-27 HBE Rear Panel
Table 3-6 HBE Rear Panel Connections
HBE Port Name Type Cable Number
N/A N/A Ground Post SX03-21916-05
CJ02 TEMP
SENSORS
DB-25 (F) SX03-21905-01
CJ03 HPA/KPA1 DB-9 (F) SX03-21906-01
CP02 OPA DC PS DB-25 (M) SX03-10919-01
RJ02 WAN RJ-45 SX03-22905-02
RJ03 LAN RJ-45 SX03-22905-03
DJ06 LNA PWR 4-pos CPC SX03-10902-01
CJ08 DC POWER 14-pos CPC SX03-10903-01
DJ02 RF IN SMA (F), 50 ohm SX03-10909-02
DJ05 ANC IN SMA (F), 50 ohm SX03-21917-06
DJ03 RF OUT SMA (F), 50 ohm SX03-21917-01
SX03-2000
0-01-M01 3-32