User's Manual

Chapter 3 Installation
3.11.2 Low Band Exciter (LBE)
During th
e installation procedure, a number of wires/cables must be connected to the LBE
rear panel.
For a Combined DRU, please refer to Table 3-7
or drawing SX03-22900-02-D06. The cables
should be connected in the order that they appear in Table 3-7
.
For an Independent DRU, please refer to Table 3-8
or drawing SX03-22900-03-D06. The
cables should be connected in the order that they appear in Table 3-8
.
Any RF cable, which is terminated with a SMA connector, should be
tightened with a 5/16” torque wrench to avoid over tightening and
damaging the cable connector or mating connector.
Figure 3-30 LBE Rear Panel
SX03-2000
0-01-M01 3-35