User's Manual

Chapter 3 Installation
3.12.3 LB Cabinet
During
the installation procedure, several external input signal connections must be made to
the LB cabinet:
 Ku-Band VSAT Antenna (V SAT)
 GPS Antenna (GPS)
Figure 3-32 LB Cabinet Cable Entrance
3.12.4 Ku-Band Antenna
The following steps should be performed to connect the Ku-Band V
SAT antenna (LBE RF
input) to the DRU:
1. Run a cable from the Ku-Band VSAT antenna to the DRU.
2. If the cable does not already have a male F connector on it, install a male F
connector on the end of the cable.
3. Attach and securely tighten the connector to the female F connector marked “V
SAT”, which is located on the bottom-left side of the DRU – see Figure 3-32
.
SX03-2000
0-01-M01 3-39