User's Manual

Chapter 4 Commissioning

4.4 Commissioning Procedure

Duri

ng the commissioning (initial turn-on) procedure, the operator will be required to

perform the following tasks:

1. Power-on the repeater

2. Configure the repeater

3. Place the repeater in broadcast mode

4.4.1 Repeater AC/DC Power-on

The rep

eater is divided into separate LB and HB cabinets. However, there are several

components (assemblies) which are shared by both cabinets, but are physically located in

only one of the cabinets. In this case, it is recommended that the HB sub-system is turned on

before the LB sub-system is turned on.

4.4.1.1 Main Disconnect

he repeater AC/DC power should be turned on in the following sequence:

1. Switch ON the repeater circuit breaker, located in the building/site electrical service

panel.

2. Switch ON the AC disconnect device, located on or near the repeater pedestal (where

applicable).

SX03-2000

0-01-M01 4-2