User's Manual
Table Of Contents
- 1.0 INTRODUCTION
- 2.0 FEATURES & OPTIONS
- 3.0 SAFETY WARNINGS
- 4.0 WARRANTY (summary)
- 5.0 UNPACKING AND INSPECTION
- 6.0 GENERAL SPECIFICATIONS
- 7.0 PRINCIPAL OF OPERATION
- 8.0 FRONT PANEL DESCRIPTION
- 9.0 REAR PANEL DESCRIPTION
- 10.0 LED Indicators
- 11.0 MAKING CONNECTIONS TO THE X75
- 12.0 INSTALLATION
- 13.0 USING THE CONTROLLER WEB BROWSER INTERFACE
- Appendix 1 – SNMP MIB Information
- Appendix 2 – Load LVD Configuration (model X75-12-A-GHHIL-S-578 only)
- Appendix 3 – Revision History
- Figure 1 - X75 Compact Integrated DC Power System
- Figure 2 - Block Schematic
- Figure 3a - Front View with Breakers (configuration A)
- Figure 3b - Front View with GMT Fuses (configuration B)
- Figure 4 - Rear Views of Base and Expansion Units
- Figure 5 - LED Indicators
- Figure 6 - Recommended Load Circuit Wire Sizes
- Figure 7 - Battery Temp. Probe & Alarm Relay Connector Pin-Out
- Figure 8 - Ethernet Connector Pin-Out
- Figure 9 - Auxiliary Connector Pin-Out
- Figure 10 - Input Current Ratings
- Figure 11 - Controller Status WEB Page (typical)
- Figure 12 - Rectifier Status WEB Page (typical)
- Figure 13 - Rectifier I²C Addressing
- Figure 14 - Controller Factory Calibration WEB Page (typical)
- Figure 15 - Controller Site Installation WEB Page (typical)
- Figure 16 - Alarm Configuration WEB Page (typical)
- Figure 17 - Controller Network Settings (typical)
- Figure 18 - Controller Alarm Log WEB Page (typical)
- Figure 19 - Controller Control Panel WEB Page (typical)
- Figure 20 - Controller System Settings WEB Page (typical)
- Figure 21 - SNMP Configuration WEB Page (typical)
- Figure 22 - Controller Help WEB Page (typical)
- Figure 23 - About UNIPOWER Telecom WEB Page (typical)
Page 30
X75 SERIES
INSTALLATION & OPERATING MANUAL
Manual No. x75-10b
x75-man-Rev10b-0514.indd
A few seconds after the SELECT button has been pressed the X75 will respond and
the status and inventory information will be updated. ‘Live’ data is presented in
the form of 8 colored indicator blocks to the left. A green block indicates a ‘good’
condition and a red block indicates a ‘bad’ condition. In addition the unit’s internal
temperature is presented on the right.
Note that Sigma Series rectiers include a single fan only and that two of the status
indicator blocks will always be grayed out.
‘Inventory’ data, presented on the right below the temperature measurement includes,
among other items, rectier model number Serial Number and Revision Number.
13.2.1 RectierInhibit(Shutdown)
The X75 includes a facility that enables the user to manually inhibit or
shutdown individual rectiers. This may be desirable when a particular
rectier is to be removed from the system for maintenance, although all
UNIPOWER rectiers are Hot-Swap, or for some other reason.
To inhibit a rectier rst dial in the I²C address of the required unit and the
click on SHUTDOWN.
To restart a rectier that has been inhibited dial in the I²C address of the
required unit and the click on RUN.
Note that any rectiers which have been inhibited will remain in this state
until they are either restarted using the above method or the AC power is
recycled.