User's Manual

ManualsBrandsUnique Broadband Systems ManualsElectronics1KW Satellite Dual Repeater Unit

Table Of Contents

1.0 INTRODUCTION
2.0 FEATURES & OPTIONS
3.0 SAFETY WARNINGS
4.0 WARRANTY (summary)
5.0 UNPACKING AND INSPECTION
6.0 GENERAL SPECIFICATIONS
7.0 PRINCIPAL OF OPERATION
8.0 FRONT PANEL DESCRIPTION
9.0 REAR PANEL DESCRIPTION
10.0 LED Indicators
11.0 MAKING CONNECTIONS TO THE X75
12.0 INSTALLATION
13.0 USING THE CONTROLLER WEB BROWSER INTERFACE
Appendix 1 – SNMP MIB Information
Appendix 2 – Load LVD Configuration (model X75-12-A-GHHIL-S-578 only)
Appendix 3 – Revision History
Figure 1 - X75 Compact Integrated DC Power System
Figure 2 - Block Schematic
Figure 3a - Front View with Breakers (configuration A)
Figure 3b - Front View with GMT Fuses (configuration B)
Figure 4 - Rear Views of Base and Expansion Units
Figure 5 - LED Indicators
Figure 6 - Recommended Load Circuit Wire Sizes
Figure 7 - Battery Temp. Probe & Alarm Relay Connector Pin-Out
Figure 8 - Ethernet Connector Pin-Out
Figure 9 - Auxiliary Connector Pin-Out
Figure 10 - Input Current Ratings
Figure 11 - Controller Status WEB Page (typical)
Figure 12 - Rectifier Status WEB Page (typical)
Figure 13 - Rectifier I²C Addressing
Figure 14 - Controller Factory Calibration WEB Page (typical)
Figure 15 - Controller Site Installation WEB Page (typical)
Figure 16 - Alarm Configuration WEB Page (typical)
Figure 17 - Controller Network Settings (typical)
Figure 18 - Controller Alarm Log WEB Page (typical)
Figure 19 - Controller Control Panel WEB Page (typical)
Figure 20 - Controller System Settings WEB Page (typical)
Figure 21 - SNMP Configuration WEB Page (typical)
Figure 22 - Controller Help WEB Page (typical)
Figure 23 - About UNIPOWER Telecom WEB Page (typical)

Page 31

X75 SERIES

INSTALLATION & OPERATING MANUAL

Manual No. x75-10b

x75-man-Rev10b-0514.indd

13.3 ControllerFactoryCalibration

The primary purpose of the Controller Factory Calibration page is to allow

UNIPOWER to setup a range of necessary calibration values to ensure correct

operation.

When this page is requested and the Java applet has loaded a dialog requesting the

Level 2 Pass code is presented. Once the pass code has been entered click ENTER

and the page will then be updated with current values after a few seconds.

Figure14-ControllerFactoryCalibrationWEBPage(typical)

NOTE: It should not normally be necessary for changes to be made to this page other

than to change the pass codes if so desired.

The factory default pass codes are:

Pass code Level 1 – 111

Pass code Level 2 – 123