User's Manual Part 1

Chapter 3 Installation
3.5 Installation Overview
The repeater can be installed by following the basic sequence below:
• Repeater set-up
o Check the installation surface structure, flatness and suitability.
o Position the repeater cabinet according to site drawings.
o Unpack the components (assemblies).
• Electronics compartment components (assemblies)
o Install the BMS 12 VDC rectifier module in the BMS mounting shelf.
o Mount the HBE in the electronics compartment.
o Mount the LBE in the electronics compartment.
o Mount the TRMS in the electronics compartment.
o Mount the dial-up modem in the electronics compartment (where applicable).
• HPA compartment components (assemblies).
o Install the DR filter box in the HPA compartment.
o Install the HPA’s in the HPA compartment.
o Install the HPA 30 VDC rectifier modules in the HPA PSU mounting shelf.
• Internal wire/cable connections
o Connect the ground, communications, RF and power wires/cables to the HBE.
o Connect the ground, communications, RF and power wires/cables to the LBE.
o Connect the ground, communications, RF and power wire/cables to the TRMS.
o Connect the ground, communications and power wire/cables to the dial-up
modem (where applicable).
• External input signal interfaces
o Connect the cable from the S-Band antenna to the S-SAT surge protector.
o Connect the cable from the Ku-Band VSAT antenna to the V SAT surge protector.
o Connect the cable from the GPS antenna to the GPS surge protector.
• Communications interface
o Connect the PSTN phone line to the Telco surge protector (where applicable).
• Shelter/room alarm connections
o Connect any shelter/room alarm contacts/sensors (where applicable) to the break
out board.
•
RF output interfaces
o Connect a broadcast antenna to Output 1 (where applicable).
o Connect a broadcast antenna to Output 2 (where applicable).
• Repeater AC power
o Connect the external ground conductor to the repeater.
o Connect the main AC power cable to the repeater.
NOTE: Detailed repeater installation information can be found in the subsequent sections of
this manual.
SX03-10000-01-M01 3-5