User's Manual
Table Of Contents
- 1.0 INTRODUCTION
- 2.0 FEATURES & OPTIONS
- 3.0 SAFETY WARNINGS
- 4.0 WARRANTY (summary)
- 5.0 UNPACKING AND INSPECTION
- 6.0 GENERAL SPECIFICATIONS
- 7.0 PRINCIPAL OF OPERATION
- 8.0 FRONT PANEL DESCRIPTION
- 9.0 REAR PANEL DESCRIPTION
- 10.0 LED Indicators
- 11.0 MAKING CONNECTIONS TO THE X75
- 12.0 INSTALLATION
- 13.0 USING THE CONTROLLER WEB BROWSER INTERFACE
- Appendix 1 – SNMPv3 MIB Information
- Appendix 2 – Load LVD (special order)
- Appendix 3 – Revision History
- Figure 1 - X75 Compact Integrated DC Power System
- Figure 2 - Block Schematic
- Figure 3a - Front View with Breakers (configuration A)
- Figure 3b - Front View with GMT Fuses (configuration B)
- Figure 4 - Rear Views of Base and Expansion Units
- Figure 5 - LED Indicators
- Figure 6 - Recommended Load Circuit Wire Sizes
- Figure 7 - Battery Temp. Probe & Alarm Relay Connector Pin-Out
- Figure 8 - Ethernet Connector Pin-Out
- Figure 9 - Auxiliary Connector Pin-Out
- Figure 10 - Input Current Ratings
- Figure 11 - Status WEB Page (typical)
- Figure 12 - Rectifier Status WEB Applet (typical)
- Figure 13 - Installation WEB Applet - system tab (typical)
- Figure 14 - Installation WEB Applet - float & tc tab (typical)
- Figure 15 - Installation WEB Applet - battery tab (typical)
- Figure 16 - Installation WEB Applet - float & tc tab (typical)
- Figure 17 - Installation WEB Applet - lvd tab (typical)
- Figure 18 - Installation WEB Applet - digital i/p tab (typical)
- Figure 19 - Installation WEB Applet - rectifiers tab (typical)
- Figure 20 - Installation WEB Applet - shunts tab (typical)
- Figure 21 - Battery Management WEB Applet (typical)
- Figure 22 - Alarm Matrix WEB Applet (typical)
- Figure 23 - Alarm Matrix WEB Applet - matrix options (typical)
- Figure 24 - Alarm Matrix WEB Applet - temperature alarm settings (typical)
- Figure 25 - Alarm Matrix WEB Applet - voltage alarm settings (typical)
- Figure 26 - Alarm Matrix WEB Applet - voltage alarm settings (typical)
- Figure 27 - Alarm Matrix WEB Applet - other alarm settings (typical)
- Figure 28 - Network Settings WEB Applet (typical)
- Figure 29 - Alarm Log WEB Applet (typical)
- Figure 30 - Data Log WEB Applet (typical)
- Figure 31 - Change Password WEB Applet
- Figure 32 - Help WEB Page
- Figure 33 - About WEB Page (typical)
Page 57
X75 SERIES - Mk3 Controller
INSTALLATION & OPERATING MANUAL
Manual No. x75mk3-11
x75-man-Rev11-0815.indd
Parameter Name Function
equalizeCurrentLimit Current above which equalization/boosting will be
terminated.
equalizeEnabled Equalize status.
ENABLED (1) or DISABLED (0)
equalizeAfterChargeEnabled Equalize extension after bulk charge status.
ENABLED (1) or DISABLED (0)
periodicEqualizeEnabled Periodic automatic equalization status.
ENABLED (1) or DISABLED (0)
lvdxOn
(x = 1 or 2)
Voltage at which LVDx will turn on. [1 only in X75]
lvdxOff
(x = 1 or 2)
Voltage at which LVDx will turn off. [1 only in X75]
lvdxLatchOffEnable
(x = 1 or 2)
LVDx latch off if a battery over temperature condition
occurs status.
ENABLED (1) or DISABLED (0)
lvdxMode
(x = 1 or 2)
LVDx mode.
AUTO (0), ON (1), OFF(2).
analogxName
(x = 1 to 4)
Name given to analog input x. [not used in X75]
analogxScale
(x = 1 to 4)
Scaling factor for analog input x. [not used in X75]
analogxUnits
(x = 1 to 4)
Units for analog input x. [not used in X75]
digitalxName
(x = 1 to 16)
Name given to digital input x. [1 only in X75]
digitalxAlarm
(x = 1 to 16)
Alarm status for the digital input x. [1 only in X75]
Alarm On Open (0), Alarm On Close (1).
rectierType Type of rectiers installed in the system. [I2C in X75]
PMBus (0), I2C (1), CAN(2).
dcWalkinEnabled DC walkin status.
DISABLED (0), ENABLED (1).
batteryOTAOn Temperature at which Battery Over Temperature
Alarm activates.
batteryOTAOff Temperature at which Battery Over Temperature
Alarm clears.
batteryUTAOn Temperature at which Battery Under Temperature
Alarm activates.
batteryUTAOff Temperature at which Battery Under Temperature
Alarm clears.
externalOTAOn Temperature at which External Over Temperature
Alarm activates.
externalOTAOff Temperature at which External Over Temperature
Alarm clears.