User's Manual

Chapter 3 Installation
3.11.1.1 S-Band Antenna
The followin
g steps should be performed to connect the S-Band antenna (HBE RF input) to
the DRU:
1. Run a cable from the S-Band antenna to the DRU.
2. If the cable does not already have a male N connector on it, install a male N
connector on the end of the cable.
3. Attach and securely tighten the connector to BC23 – see Figure 3-45
.
3.11.1.2 Ku-Band Antenna
The following steps should be performed to connect the Ku-Band V
SAT antenna (LBE RF
input) to the DRU:
1. Run a cable from the Ku-Band VSAT antenna to the DRU.
2. If the cable does not already have a male F connector on it, install a male F
connector on the end of the cable.
3. Attach and securely tighten the connector to BC12 – see Figure 3-45
.
3.11.1.3 GPS Antenna
The following steps sho
u
ld be performed to connect the GPS antenna (LBE GPS input) to the
DRU:
1. Run a cable from the GPS antenna to the DRU.
2. If the cable does not already have a male N-type connector on it, install a male N-
type connector on the end of the cable.
3. Attach and securely tighten the connector to BC24 – see Figure 3-45
.
SX03-30000-01-M01
3-54