User's Manual

Chapter 3 Installation
3.5 Installation Overview
The repeater can be
installed by following the basic sequence below:
 Repeater set-up
o Check the installation surface structure, flatness and suitability.
o Unpack the cabinets and components.
o Position the cabinets according to the site drawing(s).
o Fasten the cabinets together according to the DRU mechanical drawing(s).
 Control cabinet
 Components
o Mount the 12V battery in the control cabinet.
o Install the BMS 12 VDC rectifier module in the BMS mounting shelf.
o Mount the HBE in the control cabinet.
o Mount the LBE in the control cabinet.
o Mount the TRMS in the control cabinet.
o Mount the dial-up modem in the control cabinet (where applicable).
 Internal wire/cable connections
o Connect the positive, negative and temperature sensor wires to the battery.
o Connect the ground, communications, RF and power wires/cables to the HBE.
o Connect the ground, communications, RF and power wires/cables to the LBE.
o Connect the ground, communications, RF and power wire/cables to the TRMS.
 Inter-cabinet cable connections
o Connect the communications, RF and power wires/cables between the control
cabinet and HB HPA cabinet bulkhead panels.
o Connect the communications, RF and power wires/cables between the control
cabinet and LB HPA cabinet bulkhead panels.
o Connect the communications and RF and wires/cables between the control
cabinet and OFN cabinet.
 External input signal interfaces
o Connect a cable from the S-Band antenna to the S-BAND surge protector.
o Connect a cable from the Ku-Band VSAT antenna to the VSAT surge
protector.
o Connect a cable from the GPS antenna to the GPS surge protector.

Communications interfa
ce
o Connect a PSTN phone line to the Telco surge protector (where applicable).
 Shelter/room alarm connections
o Connect any shelter/room alarm contacts/sensors (where applicable) to the
break-out-board.
 HB HPA cabinet components
o Install the HPA’s in the HB HPA cabinet.
o Install the HPA 30 VDC rectifier modules in the HB HPA cabinet.
SX03-30000-01-M01
3-5