Installation Guide

Determining Your Build Out Area
1
Inspect Your Entryway for Obstructions
Check for any obstructions above and around your entryway that may prevent the outward swing of your new security doors
and/or their installation, such as:
 Light xtures
 Door bell
 Low overhang
 Door handle of your existing entry door
 Trees, bushes or hanging plants
Preparing Your Security Door
3
Rotate
clips 90°
Handleset Attachment
Attach your choice of locksets
with 2-3/8" backset (Sold
separately.) Fully extend the
lock bolts into the "locked"
position on the handle side of
the security door (D).
Page 2
Entry Door Jamb
Brick molding trim
Entry Door
Brick Molding (Top View)
StudStud
1" minimum
mounting
surface
1" minimum
mounting
surface
Equal or greater than Dimension B*
Equal or less than Dimension A*
*See Security Door Specications on the reverse side
Surface Mount
Surface or Recess Mount
Entry Door Jamb
Brick molding trim
Entry Door
Brick Molding (Top View)
StudStud
1" minimum
mounting
surface
1" minimum
mounting
surface
Equal or greater than Dimension B*
Equal or less than Dimension A*
*See Security Door Specications on the reverse side
Brick Molding - Recess Mount
Entry Door Jamb
1" minimum
mounting
surface
1" minimum
mounting
surface
Entry Door
Flat Trim (Top View)
Equal or greater than Dimension B*
Equal or less than Dimension A*
Flat Trim
StudStud
*See Security Door Specications on the reverse side
Surface Mount
Entry Door Jamb
1" minimum
mounting
surface
1" minimum
mounting
surface
Entry Door
Flat Trim (Top View)
Equal or greater than Dimension B*
Equal or less than Dimension A*
Flat Trim
StudStud
*See Security Door Specications on the reverse side
Surface or Recess Mount
Recess Jamb Frame
Flat Trim - Recess Mount
Determine Type and Readiness of Mounting Surface
2
Your new double security doors will require a minimum mounting surface of 1" on the trim above and on both sides of
your entry door.
Glass Removal
If your Unique Home Designs
Premium Security Door
includes glass, remove glass
before starting the installation
procedure.
Lay door panel down, exterior
side face down, loosen (do not
remove) each screw. Rotate
each clip 90°, carefully remove
the glass panel and store it in a
safe place during installation.