Installation Guide

Hang the Doors to Test Fit
7
A
B
C
D
E
Jamb-side (B) hinge
Door-side (D) hinge
Leveling
washers
Hang the security doors (C & D) on the jamb hinges (A
& B), holding the doors open at more than a 90° angle,
starting with the bottom pin rst.
More than 90°More than 90°
Top View
A
B
C
D
Lock Alignment
8
Gap between doors (C & D) and
both side jambs (A & B) should
appear equal on each side with a
minimal reveal of 1/8", up to 1/4".
NOTE: Cork or hard rubber shims are pre-
attached to inactive-side door and at the tops
of doors to ensure proper reveal. Use these
as reference.
Hinge side
Lock side
bolt should slide easily in and out of the hole and be somewhat
centered. If the bolts do not align properly with the holes,
measure the distance, up or down, of the misalignment.
Retract the bolts and remove the lock side door panel from
the hinges. Set aside. Remove the active side jamb and adjust
the height as measured, it may be necessary to remove the
top jamb also so that the active side jamb is in the proper
placement. Reinstall the side jamb and reattach the active
door panel onto the jamb. Check the operation of the locking
mechanism after all the adjustments have been made. If all
is well, reinstall the head jamb if it was removed during the
adjustment. Remember to make sure all pre-drilled holes in
all the jamb sections have mounting screws applied. Hang
the door back on the hinges and retest lock t. If necessary,
repeat until properly aligned.
Page 4
Lock Alignment
Test the alignment of the lock bolts with the lock holes by
closing both door panels and extending the bolts. Note: the
E
F
G
H
Push jamb up
into corner tight
against the top jamb.
Check with a level as
you mark each hole to
drill and again as you
install each screw
Installing the Active-side Jamb
6
Hinge
pins
face up
#8 x 1-1/4"
Mounting
screws
Important: All jambs must be positioned to
allow secure mounting to your trim framing
around the opening.
Make certain the jamb assembly is plumb, and
mark the location of the mounting holes with a
pencil. Set the jamb aside and, where marked,
pre-drill 1/8" holes.
Hold the hinge-side jamb in place, making sure the
hinge pins face up and the top end of the jamb is
butted up against the top jamb. Use a level to ensure
the jamb remains plumb and mark through the holes
E, F, G & H. Drill four 1/8" holes 3/4" deep through
the marks you made on the frame. Place the hinge-
side jamb back in place and mount it using only 2 of
the supplied #8 x 1-1/4" mounting screws (F), install
one mounting screw at the top of the active side
jamb and the other one towards the lower section of
the active side jamb. After completing section seven
successfully complete the top head jamb attachment
by installing the remaining installation screws in the
unused pre-drilled mounting holes.