Installation Guide

Installation Instructions

Select Mounting Method - Projection-mount (1A), Flush-mount (1B), or Inside-mount (1C).

Unique Home Designs - 973 N. Colorado Street, Gilbert, AZ 85233

07292013

MK976

1A & 1B

Projection-mount &

Flush-mount

Step 1 - Insert brackets into

horizontal bars on window guard

as shown. Make sure tabs of upper

brackets are pointed up and tabs of

the lower brackets are pointed down.

Note: if necessary, sand down ends of brackets

with excess paint for proper t inside horizontal bar.

Step 2 - Center brackets on

2 x 4 studs.

Step 1 Step 2

Inside-mount

Step 1 - Insert brackets into

horizontal bars on window guard

as shown. Make sure tabs of all

brackets are pointed away from the

window.

Note: if necessary, sand down ends of brackets

with excess paint for proper t inside horizontal bar.

Step 2 - Center brackets on

2 x 4 studs.

Step 1 Step 2

Position window guard to be centered with the window opening.

Position brackets by sliding post inside window guard channel so holes are centered with framework

of home around the window opening.

Make sure guard stays centered and even all around the opening. Mark center of bracket holes with

pencil and place window guard to the side.

Pre-drill holes using a 3/16" drill bit.

Place window guard back up, lining up bracket holes with the pre-drilled holes and install the

one-way screws with one-way screw driver (sold seperately).

Finial Installation (purchased seperately) - place nial on desired picket and tighten set screw

with included Alan wrench. Repeat for all nials.

Window Guard

Tools Required - Power drill, 3/16" drill bit, One-way Screw Driver (accessory sold seperately)

PAGE 1
Window Guard Installation Instructions Tools Required - Power drill, 3/16" drill bit, One-way Screw Driver (accessory sold seperately) 1 Select Mounting Method - Projection-mount (1A), Flush-mount (1B), or Inside-mount (1C). 1A & 1B Step 1 Step 2 Projection-mount & Flush-mount Step 1 - Insert brackets into horizontal bars on window guard as shown. Make sure tabs of upper brackets are pointed up and tabs of the lower brackets are pointed down.
PAGE 2
Instalación Instruciónes para del Protectores de Ventanas Herramientas necesarios - Taladro elétrico, broca de 3/16", Destornillador de una dirección (Accesorio que se vende por separado) 1 Seleccióne el método de montaje - Elija entre montaje de proyección (1A), montaje a ras (1B), o montaje de interio (1C). 1A & 1B Paso 1 Paso 2 Montaje de proyección & Montaje a ras Paso 1 - Inserte los soportes en las barras horizontales del protector de ventanas como se muestra.