Instructions / Assembly

Entry Door Jamb
Entry Door
Stucco 1 (Top View)
Stucco
Pop-Out
1" minimum
mounting
surface
1" minimum
mounting
surface
StudStud
Min. 2" Min. 2"
Determine Mounting Method and Rough Opening Measuring Points
1
The security door will require a minimum mounting surface of 1" on the trim above and on both sides of the sliding patio
door. Mounting screws must be secured to a stud in the wall. Review Figures 1-5 to determine which mounting method
you can and wish to use and the rough opening measurement.
Door is mounted with projection brackets that project 3" from mounting surface.
Entry Door Jamb
Brick molding trim
Entry Door
Brick Molding (Top View)
StudStud
1" minimum
mounting
surface
1" minimum
mounting
surface
Figure 1 Brick Molding - Surface Mount
Rough Opening
Width
Rough Opening
Width
Figure 2 Stucco 1 – Mounted between stucco pop-outs - Surface Mount
Entry Door Jamb
Entry Door
Stucco 2 (Top View)
Stucco
Pop-Out
1" minimum
mounting
surface
1" minimum
mounting
surface
StudStud
Figure 3 Stucco 2 – Mounted to front surface of stucco pop-outs - Surface Mount
Rough Opening
Width
Entry Door Jamb
1" minimum
mounting
surface
1" minimum
mounting
surface
Entry Door
Flat Trim (Top View)
Flat Trim
StudStud
Figure 4 Flat Trim - Surface Mount
Rough Opening
Width
Entry Door Jamb
Entry Door
Sloped Trim (Top View)
*Sloped trim must be replaced with at trim
to properly mount your new security door
Once trim is replaced, refer to
Figure 4 for measurement locations
Sloped Trim*
Stud
Stud
Figure 5 Sloped Trim
Figure 4 or 4a for measurement points
Page 1
MK1290 12/09/2014
LEFT ACTIVE
Door on the left will be used
Determine Door Swing
2
Left or Right?
Determine active door as
viewed from outside
(see illustrations)
Note: all doors are reversible
RIGHT ACTIVE
Door on the right will be used
MEASURING GUIDE
STEEL SECURITY DOOR
VIEW INSTALLATION VIDEOS