Installation Guide

UNIQUE UGP20G

orifices included in the packaging). When using this on NG gas, conversion must be

made by a qualified NG installer before attempting to operate the range on that gas.

For correct operation, the pressure of natural gas supplied to the regulator should be

between 4” and 5” of water column. For LP gas, the pressure supplied must be

between 10” and 12” of water column.

When checking for correct operation of the regulator, the inlet pressure must be at

least 1” more than the operating -manifold- pressure as given above. The pressure

regulator located at the back of the range manifold must remain in the supply line

regardless of whether natural or LP gas is being used.

Regulator is only good for ½ psi (14” w.c.) so test pressure must not exceed ½” psi.

Shut off the main gas supply valve before removing the old range and leave it off

until the new hook-up has been completed. Don’t forget to relight the pilot on other

gas appliances when you turn the gas back on.

Because hard piping restricts movement of the range, the use of a CSA certified

flexible metal appliance connector is recommended unless local codes require a hard-

piped connection. Never reuse an old connector when installing a new range. If the

hard piping method is used, you must carefully align the pipe; the range cannot be

moved after the connection is made.

To prevent gas leaks, use pipe joint compound resistant to LP or NG gases

(depending on set up) on all male -external- pipe threads.

1. In an easily accessible location, install a service manual gas shut off valve. Be

sure everyone operating the range knows where and how to shut off the gas

supply to the range.

2. When all connections have been made, be sure all range controls are in the

off position and turn on the main gas supply valve. Check for gas leaks by

using a soap and water solution. If a gas leak is present, shut off gas

immediately, tighten all connections, and retest for leaks.

3. Any opening in the wall behind the appliance and in the floor under the

appliance shall be sealed.

After installation:

1. Check ignition of cooktop burners.

2. Check ignition of oven burner.

3. Check for gas leaks at all gas connections (using a gas detector, never a flame)