Installation Guide

CARE AND MAINTENANCE

(continued)

REPLACING THE OVEN LIGHT

• Let the oven cavity and broil burner cool down.

• Switch off the electric supply.

• Remove the protective cover.

• Unscrew and replace the bulb with a new one suitable for high temperature

(200°~500°F)havingthesamespecications:120V60Hz,15W,E14.

• Replace the protective cover.

NOTE: Oven bulb replacement is not covered by your guarantee.

LEVELING THE RANGE

The range must be level to obtain proper operating. The four screws type lev-

eling legs located on the corners at the bottom of range should be adjusted by

turning them clockwise to make the range higher or counter-clockwise to lower

the range until the range is level. Use a level on surface units to check the

leveling of the range.

ANTI-TIP BRACKET INSTALLATION

To reduce the risk of tipping the range by abnormal usage or improper door

loading, the range must be secured by properly installing the anti-tip device

packed with the appliance.

•Placetheanti-tipbracketontheoorasshowngure.Anti-tipbracketcanbe

installed on the right and left side.

•Makethelocationsof2(x2)holesofant-tipbracketontheoor.

• Use a drill bit

•Securebrackettooorusingscrewssupplied.

• Slide appliance into position.

NOTE: If range is

relocated, the bracket

must be removed and

installed in new location.



NOTE: If range is relocated, the bracket must be removed and installed in new location.

