Installation Guide

23
MODEL NUMBER: UGP 20V PC1 S/S, UGP 20V PC1 W, UGP 20V PC1 B
Parts List: 1.Orices     2.Screwdriver  
Convertible Pressure Regulator
TherangeisshippedtooperateonNG.LPGoricesandaspecialscrewdriverfor
adjustingtheminimumameareshippedwiththeunitinaseparateenvelopewith
the manual. The inlet pressure of the gas supply shall be in accordance with the
nominal inlet pressure of the regulator used on the range or 1/2 psig maximum.
The range should be tested by pressurizing the regulator with an inlet pressure at
least1inchwatercolumnabovethemanufacturer’sspeciedmanifoldpressure
shown on the serial plate.
1. CAUTION: Before proceeding with the conversion,
shut off the gas supply to the appliance prior to dis-
connecting the electrical power
2. Locate convertible regu-
lator at the back of the
range, left side facing ap-
pliance. Using an adjust-
able wrench remove cap
and locate pin in the center
of cap
3. On the side you will see
the pin positon for use with
LPG
4.Unscrewpinandipitto
the LPG position - short
end outwards, spring on
outside (Fig 1.)
GAS RANGE CONVERSION
RL
OVEN
NOZZLE (LPG)
0.68
FL
0.9
RR
1.0
FR
0.53
0.82
BROILER
2”
2”
0.8
UGP 20V PC1 S/S
UGP 20V PC1 W
UGP 20V PC1 B
NG
LPG
Fig. 1