Installation Guide

27
Cooktop Burner Operation
Thetopburneramesizeshouldbeadjustedso
that is does not extend beyond the edge of the
cookware. As a matter of safety, it’s recommended
that you comply with these instructions.
Ahighameonasurfaceburnerisbothinefcientandunsafe.Theameshould
always be adjusted so that it is no larger than the bottom of the pan. Fluctuations
inamesizecouldbecausedbypressurevariations,improperlypositionedburn-
ers, damage or debris.
To light a burner, press the burner knob in and turn counter clockwise to
highame/ignitionposition.Youwillheartheelectronicignitionclickingas
youcontinuetoholdtheknobdownuntiltheamelights.ALLelectrodeswillspark
at a rate of approximately 2 ½ pulses (sparks) per second. Continue to hold the
knob depressed until gas ignites at the burner. Adjust the intensity of top burner
heat in the same manner described above.
Note: In the event the electronic ignition system fails, the top burners and oven
pilot can be lit by holding a lighted match near the burner head and turning the
appropriate top burner knob to the “9 o’clock position”.
TOP BURNER HEIGHT
ADJUSTING THE TOP BURNER AND OVEN FLAME
(continued)
incorrect and good flame patterns
27