Use and Care Manual

12
INSTALLATION PROCEDURE
Top and rear mount
installation
Due to the weight of the unit, it
is recommended to mount the
hood at the bottom of the upper
cabinet and then fi x it to the wall
to avoid gaps.
1. Use the installation template
cut-outs to mark the necessary
holes on the back and top
of the hood with a pencil or
marker.
2 Remove the template after
marking
3. Use the wall stud fi nder to
identify the number of drywall
anchors required.
4. Drill four (4) 5/16" (8 mm)
holes into the wall at each of
the marked locations. Insert
the drywall anchors into wall
holes and fi rmly tap them
into place. Insert screws into
anchors and leave 1/4" out for
range hood to hang on.
5. Remove an electrical and
duct access hole in the upper
cabinet.
DRYWALL ANCHORS
ELECTRICAL
ACCESS HOLE
DUCT HOLE
(USE HINGES ONLY IF NOT INSTALLING
UPPER SCREWS INTO THE TOP CABINETS)
STEPS
1. FOLD THE DASHED LINE AND PRESS IT AT THE INTERSECTION
OF THE WALL AND BOTTOM OF THE CABINET
2. TAPE OR HOLD IN PLACE
3. TRACE CUTOUTS
4. REMOVE THE TEMPLATE - DRILL AND CUT
ÉTAPES
1. PLIEZ SUR LA LIGNE POINTILLÉ ET APPUYEZ
- LA À L'INTERSECTION DU MUR ET DU BAS DE L'ARMOIRE
2. RUBAN OU TENIR EN PLACE
3. DÉCOUPES DE TRACÉ LE GABARIT
4. ENLEVEZ LE GABARIT - PERÇER ET COUPER
USE THIS SECTION UNDER THE CABINET
USE THIS SECTION ON THE WALL
FRONT
REAR
UTILISEZ CETTE SECTION SUR LE MUR
ARRIÈRE
UTILISEZ CETTE SECTION SOUS LE CABINET
AVANT
TROU ÉLECTRIQUE
ELECTRICAL ACCESS HOLE