70L / 6.0 cu. ft.
TABLE OF CONTENTS 03 07 08 08 10 12 16 16 17 19 19 22 23 23 Back Important safety notes Installation Parts list Door removal and reversal instructions DC power connection Operation Cleaning Energy saving tips Troubleshooting Appliance information Parts diagram and list Notes Contact us Limited warranty Technical specifications
IMPORTANT SAFETY NOTES IMPORTANT: After transit where the fridge has been on its side or back, ensure that the fridge is in a level, upright position for 12 hours to allow compressor fluids to redistribute evenly before use. Congratulations! You have purchased one of the most efficient refrigeration products available on the market today. The Unique 170L1 solar powered DC fridge is designed to provide years of trouble-free operation.
IMPORTANT SAFETY NOTES continued • To allow the interior to cool down properly, run the fridge for at least 4 hours empty before adding food. • This fridge is designed to operate on 12 or 24 volts DC ONLY. DO NOT CONNECT THIS FRIDGE TO AN AC (alternating current) POWER SOURCE. • This fridge is designed for domestic use only! It is intended for the storage of edible/consumable food and drinks. It is not intended for commercial or industrial use. • Never use excessive force on the handle to open the door.
IMPORTANT SAFETY NOTES continued These warnings are provided in the interest of your safety. Please ensure that you understand them all before installing or using this fridge. Your safety is of paramount importance. If you are unsure about any of these meanings or warnings, contact your local product dealer or Unique Off-Grid Appliances for assistance. PRIOR TO INSTALLATION: At delivery, please check that the fridge is complete and has not been damaged during transport.
IMPORTANT SAFETY NOTES continued supply cable. Also, be sure the electrical cable is not squeezed or bent when the appliance is being installed or moved. • Installation work and adjustments on the appliance must be carried out by qualified personnel only. Work performed by persons with inadequate technical knowledge may adversely effect the performance of the appliance, causing damage to the equipment, and void the warranty. • It is dangerous to make alterations or attempt to modify this product in any way.
INSTALLATION UNPACKING AND CLEANING Remove all packaging and securing tapes from the appliance. To avoid injury and causing damage to the appliance, be extremely cautious when using sharp or pointed tools to complete this task. Keep children away from the packaging material - DANGER OF SUFFOCATION! Wash the inside and outside of the appliance with luke warm water and a mild soap or detergent.
PARTS LIST PARTS LIST 1: Shelf 2: Freezer compartment 3: Bulb with cover 4: Thermostat 0 - 7 5: Door 6: Upper hinge 7: Lower hinge 8: Adjustable feet 9: Crisper 10: Detachable door rack 11: Middle hinge 12: Egg Tray 13: Power Cable 14: AC/DC Plug (optional for on-grid use) 4 6 2 11 3 1 5 13 12 10 14 AC/DC plug (optional for on-grid use) *sold separately 8 9 7 DOOR REMOVAL AND REVERSAL The default left side orientation of the door can be changed to the right side.
DOOR REMOVAL AND REVERSAL continued 8. Unscrew the stop block model on the bottom right of fridge door (A-9) and fix the stop block model to the bottom of left of fridge door (C-9) 9. Unscrew the middle hinge (A-7) 10. Remove the freezer door (A-4) 11. Unscrew the stop block model on the right bottom of freezer door (A-5) and fix the stop block model to the left bottom of freezer door (C-5) 12.
DC POWER CONNECTION IMPORTANT: After reversing the door hinge, the door gasket may be loose. Should you notice a gap between the gasket and the cabinet, use a hairdryer or heat gun and heat the gasket while on the appliance. The gasket will expand to meet the cabinet. Allow 30 mins to cool before opening. A correct gasket positioning is the key to prevent refrigerated air from escaping.
DC POWER CONNECTION continued IN-LINE FUSE A 15A in-line fuse is provided with this fridge in order to protect the wiring. For 12V/24V operation, use a 15A fuse. A standard automobile fuse is recommended and the fuse should be wired to the positive (“+”) side of the system close to the positive battery terminal. A 15A fuse is provided with this fridge/freezer.
OPERATION Your Unique fridge, like any battery-powered refrigerating appliance, requires different care than appliances plugged into an electric utility. Prudent operation is the key to extended service. STARTING THE FRIDGE After the fridge has been properly connected to the 12 or 24 V DC power source, the compressor will automatically turn on and the cabinet will begin cooling. Allow the cabinet to cool for at least 4 hours prior to adding foodstuff.
OPERATION continued ADJUSTMENTS As the ambient temperature changes with the season, it may be necessary to adjust the thermostat to achieve the proper internal temperature. If the room/ambient temperature approaches the appliance’s internal operating temperature, the appliance will not function as it should. The appliance will tend to run colder during these conditions and it may be necessary to turn the thermostat to a warmer setting (lower number).
OPERATION continued DEFROSTING Before cleaning or repositioning the fridge, you must DISCONNECT the appliance from the electrical power supply. DEFROSTING THE UNIT As solar fridges do not have automatic defrost the fridge compartment will become progressively covered with frost. This should be removed periodically with a plastic scraper. However, when the ice becomes very thick on the interior walls, complete defrosting should be carried out.
OPERATION continued WATER CATCH BASIN There is a water catch basin located at the back of the fridge for excess water or as a result of defrosting. The hot condenser coil runs into the water catch basin and evaporates the water slowly: NOTE: Take notice when doing a complete defrost as the water catch basin could overfill with large volumes of water going in the water catch basin all at once.
CLEANING Internal Cleaning Wash the inside of the appliance with luke warm water and a mild soap. Never use abrasive or corrosive cleaning agents, steel wool, scouring sponges, chemical cleaning agents, or highly perfumed cleaning products to clean the interior as these will damage the surface and leave behind a strong odor. A sponge, towel, or soft brush is recommended. Wash with a mixture of two tablespoons (30ml) of baking soda to 1 quart (1.14L) warm water.
TROUBLESHOOTING Before contacting a service technician, your local product dealer or Unique Off-Grid Appliances, please check the following points. If you contact a technician to repair a fault listed below, or to repair a fault caused by misuse, abuse, or faulty installation, a charge will be made even if the appliance is under warranty. PROBLEM SOLUTION Appliance is connected to power, but does not operate • Check if 12V or 24V DC is present at the appliance.
TROUBLESHOOTING continued Excessive frost and ice has built up • Is the weather hot and humid? If so, this will increase the rate of frost build-up in the cabinet. • Ensure that stored food is properly packaged. • Check that the door is closed and has a good seal, and that nothing is preventing the door from closing properly. • Large quantities of food have recently been placed in the fridge/freezer, and/or the door is frequently opened.
UGP-170L1 PARTS DIAGRAM AND LIST 19
PARTS DIAGRAM AND LIST continued 20 Item # Part # 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 UGP-BCD170-1 UGP-BCD170-2 UGP-BCD170-3 UGP-BCD170-4 UGP-BCD170-5 UGP-BCD170-6 UGP-BCD170-7 UGP-BCD170-8 UGP-BCD170-9 UGP-BCD170-10 UGP-BCD170-11 UGP-BCD170-12 UGP-BCD170-13 UGP-BCD170-14 UGP-BCD170-15 UGP-BCD170-16 UGP-BCD170-17 UGP-BCD170-18 UGP-BCD170-19 UGP-BCD170-20 UGP-BCD170-21 UGP-BCD170-22 UGP-BCD170-23 UGP-BCD170-24 UGP-BCD170-25 UGP-BCD170-26 UGP-BCD170-27 UGP-BCD
PARTS DIAGRAM AND LIST continued Item # Part # 31 32 33 34 35 36 37 38 39 40 41 42 UGP-BCD170-31 UGP-BCD170-32 UGP-BCD170-33 UGP-BCD170-34 UGP-BCD170-35 UGP-BCD170-36 UGP-BCD170-37 UGP-BCD170-38 UGP-BCD170-39 UGP-BCD170-40 UGP-BCD170-41 UGP-BCD170-42 Description Compressor connect cable The speed resistance cable Trouble light and cable Plug Back cover Compressor base Process tube Compressor Drip tray Drier filter flush condenser Screw ST4.
APPLIANCE INFORMATION (manual copy - keep with your records) To make care and servicing of your solar powered DC fridge easy and efficient, please record the following information for future reference: Model: Serial Number: Purchased From: Date Purchased: NOTES 22
CONTACT US For questions related to the operation, safety or the purchase of your fridge, please contact your dealer for more information. For general information, contact our customer service department: • Toll-free: 1-877-427-2266 or 1-905-827-6154 (available during regular business hours, 8:30 am to 4:30 pm, EST. • Email: info@UniqueOffGrid.com Website: www.uniqueoffgrid.com • Address: Unique Gas Products Ltd.
TECHNICAL SPECIFICATIONS MODEL UGP-170L1 SIZE total: 6.0 cu/ft, 165 litres OPERATION •12V/24V DIMENSIONS (unboxed) H 50.6” x W 19.2” x D 22.8” H 128.5 cm x W 49 cm x D 58 cm WEIGHT 76.1 lbs./34.5 kg DC POWER 12V/24V TOTAL WATT HR. PULL DOWN (24 DC) 590 Wh/24hrs (set to -14˚C freezer/+4˚C fridge performance in a +25˚C ambient) TOTAL WATT HR. STABLE RUNNING (24 DC) 545 Wh/24hrs (set to -14˚C freezer/+4˚C fridge performance in a +25˚C ambient) POWER CONSUMPTION 12V/24V 52 W AV.