User Manual

23
24” MODEL
GAS RANGE CONVERSION
ATTENTION: YOUR PRODUCT IS PRE-INSTALLED WITH NATURAL GAS
INJECTORS AND REGULATOR.
IF YOU ARE USING LP GAS, PLEASE REFER TO THE INSTALLATION
INSTRUCTIONS INCLUDED WITH THE CONVERSION KIT.
Convertible Pressure Regulator
TherangeisshippedtooperateonNG.LPGorices
foradjustingtheminimumameareshippedwiththe
unit in a separate envelope with the manual. The inlet
pressure of the gas supply shall be in accordance with
the nominal inlet pressure of the regulator used on the
range or
1
/
2
psig maximum. The range should be tested
by pressurizing the regulator with an inlet pressure at
least 1 inch water column above the manufacturer’s
speciedmanifoldpressureshownontheserialplate.
1.Orices
Parts List:
1. CAUTION: Before proceeding with
the conversion, shut off the gas
supply to the appliance prior to
disconnecting the electrical power
2. Locate convertible regulator at the
back of the range, left side facing
back of appliance. Unscrew cap to
locate pin.
3. On the side of the pin you will see the respective marking for LPG and NG.
4.UnscrewpinandipittotheLPGposition(arrowfacingcapindicating
correct setting)
5. Replace the cap back on the regulator
Top Burner Orices
6. Remove the grates, burners and
burner caps from the range to
accesstheorices.