User Manual

39
CARE AND MAINTENANCE
(continued)
Repair Parts
When repair parts are needed, contact the dealer from whom the range
was purchased. In case your range was purchased from a source other
than an appliance dealer, you may prefer to contact the manufacturer at
the address shown in this manual.
Moisture
During the initial heat-up of your range, the heat mixing with the cooler air
in the oven cavity may produce fogging of the door glass or a collection
ofwateronthedoor.Topreventthis,opentheovendoorfortherstfew
seconds of initial oven heat-up. This will allow the moist air within the
oven to escape, without the forming of visible moisture on the range. The
amount of moisture will depend upon the humidity of the air and water
content of the food being cooked. Fogging and even dripping water will
usually occur in geographic locations of high humidity.
BURNERS AND CAST-IRON GRIDS
• These parts can be removed and cleaned with appropriate products.
• Aftercleaning,theburnersandtheiramedistributorsmustbewelldriedand
correctly replaced.
• Itisveryimportanttocheckthattheburneramedistributorandthecaphas
been correctly positioned - failure to do so can cause serious problems.
• In appliances with electric ignition keep the electrode clean so that the sparks
always strike.
Note: To avoid damage to the electric ignition do not use it when the
burners are not in place.