Manual and Installation Guide

OPERATION OF RANGE
(continued)
3. Press the knob inward and
hold to activate the electronic
ignition. Note that you will
hear a “clicking” noise. Hold
the knob pressed inward until
the oven burner is lit. Once
the oven burner is lit, release
the knob.
In case of power outage, you can manually light the burner by pressing the knob
inward and immediately approach a lighted match to the opening “A” (see the dia-
gram above).
Never continue this operation for more than 15 seconds. If the
burner has still not ignited, wait for about 1 minute prior to
repeating the ignition.
4.Whenusingtherangeforthersttimeorafterlongperiodofnon-usage,keep
pressing the knob inward for approximately 10 – 15 seconds after the burner has lit
to ensure the gas valve has been accurately primed.
5. Close the oven door slowly and adjust the burner accordingly to the desired
temperature.Iftheameextinguishesforanyreason,thesafetyvalvewillauto-
matically shut off the gas supply to the burner.
Tore-lighttheburner,rstturntheovencontrolknobtotheOFFposition,waitfor
at least 1 minute and then repeat the lighting procedure.
Attention: the oven door becomes very hot during operation. Keep
children away.
MOISTURE IMPORTANT
If sparking does not occur when the oven thermostat knob is turned on during the
initialattempttouse,orafterseveraldaysofnon-use,itCOULDBEtheresultof
moisture build-up in the ceramic sleeve of the oven electrode. This may happen in
areas with high humidity, or if food having high water content is cooked. This mois-
ture can be driven out of the ignitor by lighting the pilot and operating the oven for
a few minutes.
A

33