Owners Manual

Repair Parts

When repair parts are needed, contact the dealer from whom the range was

purchased. In case your range was purchased from a source other than an appliance

dealer, you may prefer to contact the manufacturer at the address shown in this

manual.

Moisture

During the initial heat-up of your range, the heat mixing with the cooler air in the

oven cavity may produce fogging of the door glass or a collection of water on the

door. To prevent this, open the oven door for the first few seconds of initial oven

heat-up. This will allow the moist air within the oven to escape, without the forming

of visible moisture on the range. The amount of moisture will depend upon the

humidity of the air and water content of the food being cooked. Fogging and even

dripping water will usually occur in geographic locations of high humidity.

LIFT-OFF DOORS

Lift-Off Oven Door (on some models)

The oven door is removable but it is heavy - you may need help removing and

replacing the door.

To remove the door, open it to the full open position. Raise the locking mechanism

by applying force to the locking mechanism lever. Needle nose plyers can also be

used to lift up on the locking mechanism. Raise the oven door until each locking

mechanism lines up with the hinge cut out on the door. Grasp firmly on each side

and lift the door straight up and off the hinges.

To replace the door, position the slots in the bottom of the door squarely over the

hinges. Then lower the door slowly and evenly over both hinges at the same time.

Once at the fully open position, press locking mechanism back in place and close the

door.

U N I Q U E U G P 3 0 G